User manual LG PQRCHCA0Q

[. . . ] ENGLISH ITALIANO ESPAÑOL FRANÇAIS DEUTSCH PORTUGUESE РУССКИЙ ЯЗЫК OWNER’S & INSTALLATION MANUAL SIMPLE WIRED REMOTE CONTROLLER Please read this manual carefully before operating your set and retain it for future reference. Com 2 TIPS FOR SAVING ENERGY ENGLISH TIPS FOR SAVING ENERGY Here are some tips that will help you minimize the power consumption when you use the air conditioner. You can use your air conditioner more efficiently by referring to the instructions below: • Do not cool excessively indoors. This may be harmful for your health and may consume more electricity. [. . . ] - Setup direction: the surface of wall reclamation, upper, right - If setting up remote controller cable into upper and right side, please set up after removing remote controller cable guide groove. ❈ Remove guide groove with long nose. ‘ Reclamation to the surface of the wall ② Upper part guide groove ③ Right part guide groove Wall Side Wall Side When separating remote controller from setup board, as the picture below, after inserting into the lower separating hole using screw driver and then, spinning clockwise, remote controller is separated. - Please be careful not to damage the inside components when separating. <Separating order> Wall Side <Wire guide grooves> Wall Side 3 Please connect indoor unit and remote controller using connection cable. 8 INSTALLATION INSTRUCTION ENGLISH Group Control GND Signal wire 12V FAN SPEED TEMP ROOM TEMP GND Signal wire 1 When installing more than 2 units of air conditioner to one wired remote controller, please connect as the right figure. - If it is not event communication indoor unit, set the unit as slave. - Check for event communication through the product manual. 2 When installing more than 2 wired remote controllers to one air conditioner, please connect as the right picture. - When installing more than 2 units of wired remote controller to one air conditioner, set one wired remote controller as master and the others all as slaves, as shown in the right picture. - You cannot control the group as shown in the right for some products. - Refer to the product manual for more detail. When controlling multiple indoor units with event communication function with one remote controller, you must change the master/slave setting from the indoor unit. - For ceiling type cassette and duct product group, change the switch setting of the indoor PCB. - For wall-mount type and stand type product, change the master/slave setting with the wireless remote controller. (Refer to wireless remote controller manual for detail) ❈ When installing 2 remote controllers to one indoor unit with event communication function, set the master/slave of the remote controller. (Refer to remote controller master/slave selection) When controlling the group, some functions excluding basic operation setting, fan level Min/Mid/Max, remote controller lock setting and time setting may be limited. 3 When installing more than 2 wired remote controllers to one air conditioner, please connect as the right picture. GND Signal wire 12V B Y R B Y R GND Signal wire 12V FAN SPEED TEMP ROOM TEMP TEMP FAN SPEED ROOM TEMP MASTER SLAVE ON 1 2 3 4 5 6 7 8 #3 switch OFF: Master (Factory default setting) - When installing more than 2 units of wired remote controller to one air conditioner, set one wired remote controller as master and the others all as slaves, as shown in the right picture. - You cannot control the group as shown in the right for some products. - Refer to the product manual for more detail. - When controlling in groups, set the master/slaver of the remote controller. [. . . ] Button and button Simultaneouslly for more than 3 seconds After the setting has been completed. NOTE • When setting ESP value on the product without very weak wind or power wind function, it may not work. € Please be careful not to change the ESP value for each fan step. € It does not work to setup ESP value for very low/power step for some product. [. . . ]