User manual LG V-KC902CES

[. . . ] Wash air filter and motor safety filter with water. â· Do not wash filters with hot water. Air filter and motor safety filter should be cleaned in the above case. To clean the exhaust filter, remove the exhaust filter cover on the body by rotating it counterclockwise. [. . . ] Before filling water, the cleaner shall be powered off and unplugged from the socket; also, hose handle shall be put on the floor. When the indicator of "Water filling" on the brush head flashes, you shall stop cleaning with the steam brush head and unplug from the socket. Open the water inlet on the brush head and fill proper water with the measuring cup (250ml). Fasten the water inlet cover on the brush head as per the figure, revolving toward right until the clicking sound. When you power on the cleaner after filling water, the indicator of "Water filling" lights up for 30 seconds to 1 minute. You could continue cleaning after the indicator of "steam" lights up. Method for replacing or washing the duster Note: The duster shall be replaced after power off. Take off the duster board from the steam brush head. When replacing the duster, you shall stick the duster with the white side on the board. Take off the duster board from the steam brush head. When replacing the duster, you shall stick the duster with the white side on the board. Note: Use of duster without completely drying may incur electric shock or damage the cleaner. Stick the duster properly, for fear of blocking the suction hole of the steam brush head. The time to moisten the duster may differ as for different usage or duration of the steam brush head; replacing a clean duster may make the cleaning easier. Turn off the switch and unplug from the socket. Clean and dry the used duster immediately; otherwise it may lead to peculiar smell if placing for some time. The steam brush head shall be maintained on the specific pad rather than directly on the floor when it is still hot; otherwise it may damage the floor. The remaining water in the brush head shall be completely dried, if the cleaner stays idle for a long period. Note: such maintenance shall be done after the brush head is completely cooled up; otherwise it may incur burns or damage the cleaner. Also, the drawtube shall be separated from the brush head first. [. . . ] Pull out part of the power cord and then re-scroll it. Please put forth your strength to pull out the power cord, which will not be damaged. The power cord entwined inside the machine or it is caused by high temperature in the summer. The cord is bended inside the machine or not coiled around the winder. [. . . ]