User manual LG VC9003NT

[. . . ] This information contains important instructions for the safe use and maintenance of the vacuum cleaner. Especially, please read all of the information on page 4, 5, 6 for your safety. Please keep this manual in an easily accessible place and refer to it anytime. Using carpet and floor nozzle / Hard floor nozzle . [. . . ] Do not dry the filter in an oven or microwave. Do not dry the filter in a clothes dryer. If the power cord is damaged, it must be replaced by an approved LG Electronics Service Agent to avoid a hazard. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. This vacuum cleaner has a special thermostat that protects the vacuum cleaner in case of motor overheating. If the vacuum cleaner suddenly shuts off, turn off the switch and unplug the vacuum cleaner. Check the vacuum cleaner for possible source of overheating such as a full dust tank, a blocked hose or clogged filter. If these conditions are found, fix them and wait at least 30 minutes before attempting to use the vacuum cleaner. After the 30 minute period, plug the vacuum cleaner back in and turn on the switch. If the vacuum cleaner still does not run, contact a qualified electrician. Push the nozzle into the telescopic pipe. Push telescopic pipe firmly into hose handle. Connecting the hose to the vacuum cleaner Relier le flexible à l'aspirateur Push the fitting pipe on the flexible hose into the attachment point on the vacuum cleaner. To remove the flexible hose from the vacuum cleaner, press the button situated on the fitting pipe, then pull the fitting pipe out of the vacuum cleaner. Pull out the power cord to the desired length and plug into the socket. Place the control knob of the hose handle to the required position. Press the cord reel button to rewind the power cord after use. Always empty the dust tank when the dust tank level reaches the MAX line. To store during vacuuming, for example to move a small piece of furniture or a rug, use park mode to support the flexible hose and nozzle. - Slide the hook on the nozzle into the slot on the side of vacuum cleaner. When you have switched off and unplugged the vacuum cleaner, press the cord reel button to automatically rewind the cord. [. . . ] Insert the attachment projections on bottom plate to the vacuum nozzle grooves. The dust tank needs emptying when the dust tank level reaches the MAX line. Turn off the vacuum cleaner and unplug it. Grasp the handle of the tank and then press the tank separation Pull out the dust tank. [. . . ]