User manual LG VC9176PH

[. . . ] This appliance complies with the following EC Directives :-2006/95/EC Low Voltage Directive -2004/108/EC EMC Directive. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word "WARNING" or "CAUTION. This symbol will alert you to hazards or unsafe practices which could cause serious bodily harm or death. [. . . ] Do not use vacuum cleaner to pick up sharp hard objects, small toys, pins, paper clips, etc. They may damage the cleaner or dust bin. Put the vacuum cleaner away after use to prevent tripping over it. The vacuum cleaner is not intended to use by young children or infirm people without supervision. Only use parts produced or recommended by LG Electronics Service Agents. Use only with LG recommended or approved attachments and accessories. To avoid personal injury and to prevent the machine from falling when cleaning stairs, always place it at the bottom of stairs. You should grasp the carrier handle when you are moving the vacuum cleaner. Make sure the filters (exhaust filter and air filter) are completely dry before replacing in the machine. Do not dry the filter in an oven or microwave. Do not dry the filter in a clothes dryer. If the power cord is damaged, it must be replaced by an approved LG Electronics Service Agent to avoid a hazard. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. This vacuum cleaner has a special thermostat that protects the vacuum cleaner in case of motor overheating. If the vacuum cleaner suddenly shuts off, turn off the switch and unplug the vacuum cleaner. Check the vacuum cleaner for possible source of overheating such as a full dust tank, a blocked hose or clogged filter. If these conditions are found, fix them and wait at least 30 minutes before attempting to use the vacuum cleaner. After the 30 minute period, plug the vacuum cleaner back in and turn on the switch. If the vacuum cleaner still does not run, contact a qualified electrician. Connecting the hose to the vacuum cleaner Raccordement du flexible à l'aspirateur Push the fitting pipe on the flexible hose into the attachment point on the vacuum cleaner. To remove the flexible hose from the vacuum cleaner, press the button situated on the fitting pipe, then pull the fitting pipe out of the vacuum cleaner. [. . . ] Turn off the vacuum cleaner and unplug it. Check the telescopic pipe, flexible hose and cleaning tool for blockages or obstructions. Check that dust separator is not clogged with obstruction. Check that the exhaust filter is not clogged. [. . . ]