User manual LG VR1129RB

[. . . ] 4 MAKE sure that the unit is correctly ventilated at all times ; do NOT place clothing or other materials over it. 5 NEVER spill any kind of liquid into the unit. Should this happen, unplug the unit and contact an authorized service center. 6 Do NOT insert anything between the air outlet blades because the inner fan may be damaged and could cause injury. [. . . ] Insert the two batteries, taking care to respect the polarities : + on the battery with + on the remote control. - on the battery with - on the remote control. Close the cover by sliding it back until it clicks into place. 1 2 3 E-7 Cooling Your Room You must select the Cool mode if you wish to lower the temperature in your room. You can also set the Fan speed. Remote Control Control Panel 1 Press the (On/Off) button. Result: The air conditioner starts up in the cool mode(Fan speed will not be changed). The unit beeps twice. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: Plugged in Stopped It will start up normally after three minutes. 2 If the temperature is not displayed on the control panel: Press the button on the remote control or Press the button on the unit one or more times until the temperature is displayed. Result: The unit beeps each time you press the / The air conditioner starts up in the Cool mode. button. 3 You can change modes at any time. To adjust the temperature, press the or buttons on the remote control or unit one or more times until the desired temperature is displayed. The temperature can be set between 18°C and 30°C. Result: Each time you press the or buttons: ­ The temperature is adjusted by 1°C and displayed on the control panel ­ The unit beeps The air conditioner starts cooling, if the room temperature is higher than the selected temperature. If the room temperature reaches the set temperature, the air conditioner stops cooling, but the fan is still operating. 4 To set the fan speed: Press the , or button on the remote control as desired. or Press the button on the unit one or more times until the desired Fan speed(F1, F2 or F3) is displayed. The operating time can be set between 1 and 24 hours. Result: Each time you press the button: ­ The time is adjusted by 1 hour and displayed on the control panel ­ The unit beeps The operating time is displayed and decreases automatically to indicate the remaining time. The air conditioner switches off automatically when the operating time reaches zero. You can select the fan speed, temperature, air flow direction and Energy saving mode after setting the On timer and Off timer mode. However, when you change the mode, the On timer and Off timer mode is canceled. To Cancel the Off Timer To cancel the timer, press: Timer on the remote control or unit one or more times until "--" is displayed. or The (On/Off) button on the remote control or unit. E-13 Setting the Sleep Timer The Sleep Timer can be used when you are cooling your room to switch the air conditioner off automatically after 8 hours. Remote Control Control Panel 1 If you wish to switch the unit off at a specific time, refer to page 13. Make sure that you have selected the Cool mode. 2 Press the or Press the Result: button on the remote control button on the unit. Each time you press a button, the unit beeps. The remaining time is displayed and decreased by 1 hour automatically to indicate the remaining time. The air conditioner will be controlled as illustration below. Cooling When the temperature has been increased by 1°C (after 1 hour), it is maintained for 7 hours. To Cancel the Sleep Timer To cancel the timer, press: button on the remote control. The SLEEP indicator is no longer displayed. The air conditioner operates in the mode selected last. [. . . ] Check that there are no obstacles between you and the unit. Replace the remote control batteries if necessary. Check that you are close enough to the unit (seven metres/yards or less). Check that you are pointing the remote control at the remote control sensor on the unit. [. . . ]