User manual LG WD-14030 RDB

[. . . ] Cleaning and Maintenance Warning: Before cleaning the washing machine interior, unplug the electrical power cord to avoid the risk of electric shock. Electrical connection 1. Do not use an extension cord or double adapter. Have damaged supply cords replaced by the manufacturer or its service agents or a similarly qualified person to prevent danger. Always unplug the machine and turn off the water supply after use. [. . . ] plastic film, Styrofoam) can be dangerous for children. Keep all packaging well away from children and do not allow children to play inside the bowl as they may become trapped. CAUTION about the floor surface · The installation surface must be clean, dry and level. · Install washing machine on a flat hard floor. · Poorly constructed timber base floors can contribute to excessive noise and vibration. · Proper placement and levelling of the washing machine ensure long, regular and reliable operation. · The washing machine must be perfectly level and firmly in position. · It must not "see-saw" across corners under load. · The installation surface must be clean, free from floor wax and other lubricant coatings. · Do not allow the feet of the washing machine to get wet. If feet of the washing machine get wet, slipping may occur. N Troubleshooting · Water supply is not adequate in area · Water supply taps are not completely open. · Water inlet hose(s) are kinked. · The filter of the inlet hose(s) are clogged. · Drain hose is kinked or clogged. filter by turning to the left Remove any extraneous matter from the pump filter After cleaning, refit the drain filter cap and tighten it by turning it clockwise. insert the drain plug Close the lower cover Installation of drain hose · Water overfills due to the faulty water valve. Cleaning the dispenser drawer ca. 145 cm · Water level sensor has malfunctioned. · The washer experienced a power failure. · Water leaks · Check water supply. 1 2 3 4 Pull out the dispenser drawer Clean the dispenser drawer under flowing water Clean inside the recess with an old toothbrush Insert the dispenser drawer ca. 60 cm Once you have finished cleaning, replace the drawer and run a rinse cycle without laundry or soap. 5 ca. If " " is not released, unplug power plug and call for service. max. 60 cm 60 ­ 100 cm Cleaning in general Important: Do not use methylated spirits, solvents or similar products. Exterior Proper care of your washing machine can extend its service life. [. . . ] Program Temperature Program Temperature Cotton Cold, 30°C, 40°C, 60°C, 95°C Baby Care 40°C, 60°C, 95°C Cotton Quick Cold, 30°C, 40°C, 60°C Refresh No choose Synthetic Cold, 30°C, 40°C, 60°C Allergy Care 60°C How to use Refresh Cycle 1 2 3 4 Woven and Loopknit Materials - Some woven and loopknit materials may shrinks, by varying amounts, depending on their quality. - Always stretch them out immediately after drying. Rubber and Plastics - Do not dry any items made from or containing rubber or plastics, such as: a) aprons, bibs, chair covers b) curtains and table cloths c) bathmats Beep on / off The Beep on/off function can be set only during the washing cycle. To set the Beep On/Off function follow the below steps. Turn on the washing machine (by pressing the Power button). [. . . ]