User manual LG WM-12336FD

[. . . ] If the water pipe is made of plastic, it does not have the earth effect. Gas pipe G Never connect the earth wire to the gas pipe, lightning arrester. G Insert the power plug into the outlet. [. . . ] Earth G Before connecting the power plug, check if the wire voltage setting of the washer matches the out let voltage. G Connecting the drain hose · Connect the drain hose to the outlet of the plunger valve located at the back side of the washing machine. · Push the clamp toward the body of the washing machine as shown in the figure. 8 WARNING-THIS APPLIANCE MUST BE EARTHED. Other earthing method G Voltage Change (Only for Dual Voltage) 1. Unplug the power cord from the electric outle, Use screwdriver to remove back cover 2. Remove the bag covering the lead wire couplers. To change the voltage setting from 220V to 110(127)V, disconnect the coupler marked "220V" and connect the coupler marked "110(127)V", to change the voltage setting from 110(127)V to 220V, disconnect the coupler marked "110(127)V" and connect the coupler marked "220V". Cover the couplers with the bag and reattach the back cover. Be sure to indicate the new voltage setting on the "Present Voltage" label for future reference. After connecting the earth wire to the earth copper plate, bury it at least 75cm deep under the wet ground. Earth wire Earth copper plate 75cm G Connect to the earthing-only outlet. G Earth wire When installing it in an area where earthing is not possible, purchase a short-circuit breaker connect it to the outlet. Short-circuit breaker Washing Caution : Don't rotate knob over on spot curve. If the spin dryer basket is off-balance and vibrates excessively, stop the spinning, rearrange the clothes evenly, and then resume spinning. Safety cover 1. Remove the laundry from the spin dryer basket and close the spin dryer cover. If there is water in the wash tub, set the drain selector to "DRAIN" in order to drain it out. (For Pump Model Only : and then put it back to ) "OFF" Disconnect the power cord from the electrical outlet. Ensure without fail the drain selector is turned to "OFF" Position after using 6. If washing and spinning must be operated together, starting washing and spinning operation shall be done at the same time to cope with EMC requirement. TROUBLESHOOTING GUIDE Before Requesting Service Problem Motor does not operate, Spin dryer basket does not operate. No draining For Non-Pump Model For Pump Model Checking point Is the power cord firmly plugged in? [. . . ] No draining For Non-Pump Model For Pump Model Checking point Is the power cord firmly plugged in?Is the timer turned to a suitable point except "OFF" ?Is there any clothing dropped between the basket and tub? [. . . ]