User manual LIEBHERR CTPESF 3016 COMFORT

[. . . ] Conformity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . External dimensions of the appliance. . . . . . . . . . . . . . . . . . . . . . . Saving energy. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . General safety information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If the bearing parts are not screwed into place firmly enough, the door may drop out. What is more, the door may not close and therefore the appliance may fail to cool properly. u Screw on the bearing brackets/bearing pins tightly (4 Nm). u Check all of the screws and retighten if necessary. 4. 4 Insertion into a row of kitchen units 4. 6 Connecting the appliance NOTICE Risk of damage to the electronic control system!u Do not use stand-alone inverters (conversion of d. c. to a. c. / three-phase) or energy saving plugs. WARNING Fire and overheating hazard!u Do not use extension cables or multiple socket outlets. The type of current (alternating current) and voltage at the installation site have to conform with the data on the type plate (see Appliance at a glance). Connect the appliance only with a properly installed socket outlet with earthing contact. The socket outlet must be fused with 10 A or higher. It must be easily accessible so that the appliance can be quickly disconnected from the supply in an emergency. u To confirm: Press the SuperFrost button Fig. w The brightness is adjusted to the new value. u To deactivate the setting mode: Press the On/Off button -oru Wait for 5 minutes. w The temperature is indicated again in the temperature display. 5. 3. 1 Muting the door alarm The audible alarm can be muted when the door is open. The sound switch-off function is active as long as the door is left open. 3 (1). 5. 4 Temperature alarm The audible alarm sounds if the freezer temperature is not cold enough. The temperature display and the alarm symbol Fig. The cause of the temperature being too high may be: - warm fresh food was placed inside - too much warm ambient air flowed in when rearranging and removing food - power failure for some time - the appliance is faulty The audible alarm is automatically silenced, the alarm symbol Fig. 3 (10) goes out and the temperature display stops flashing when the temperature is sufficiently cold again. If the alarm status persists: (see Malfunction). Note Food may be spoilt if the temperature is not cold enough. [. . . ] 3 (4) flashes together with the temperature display. The door of the appliance is not properly closed. The appliance was opened too frequently or for too long. u Wait until the appliance reaches the required temperature itself. [. . . ]