User manual LIEBHERR WKB 1812 VINOTHEK

[. . . ] Conformity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Saving energy. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . General safety information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Controls and displays. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 2 (1) Temperature controller (2) SuperFrost button (3) Temperature display*/ status display* (4) Alarm button (luminous display and audible alarm) (5) LED alarm (luminous display) 3. 2 Temperature display* The following are displayed in normal operation: - the set freezing temperature 4 Putting into operation 4. 1 Transporting the appliance CAUTION Risk of injury and danger of damage as a result of incorrect transport!u Transport the appliance in a packed condition. u Do not transport the appliance without assistance. 3 Control 4. 2 Installing the appliance In the event that the appliance is damaged, contact the supplier immediately before connecting to the mains. The floor at the site must be flat and level. Do not install the appliance in a location where it is exposed to direct radiation of the sun, next to a cooker, heater and similar. Do not install the appliance without assistance. Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m2 per 8 g of R 600a refrigerant used in the appliance. If the room in which the appliance is installed is too small, a flammable gas-air mixture may form in the event of a leakage in the refrigeration circuit. The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance. Fit the appliance in stable kitchen units only. The packaging is made of recyclable materials: - corrugated board/cardboard - expanded polystyrene parts - polythene bags and sheets - polypropylene straps - nailed wooden frame with polyethylene panel* u Take the packaging material to an official collecting point. 4. 4 Connecting the appliance NOTICE Risk of damage to the electronic control system!It shines after the Alarm* button has been pressed. The cause of the temperature being too high may be: - warm fresh food was placed inside - too much warm ambient air flowed in when rearranging and removing food - power failure for some time - the appliance is faulty The audible warning signal is automatically silenced and the Alarm LED display goes out when the temperature is sufficiently cold again. If the alarm status persists: (see Malfunction). Note Food may be spoilt if the temperature is not cold enough. Do not consume spoiled food. 4. 3 Disposing of packaging WARNING Danger of suffocation due to packing material and plastic film!u Do not allow children to play with packing material. 4 Control 5. 1. 1 Muting the temperature alarm* The audible alarm can be muted. When the temperature is sufficiently cold again, the alarm function is active again. The noise of the refrigeration unit may be temporarily louder as a result. In addition, frozen food already in storage is given a "cold reserve". The food stays frozen longer as a result when you defrost the appliance. The maximum amount of fresh food which can be frozen in 24 h is indicated on the type plate under "freezing capacity . . . [. . . ] It is briefly a little louder when the refrigeration unit (the motor) switches on. The refrigeration increases automatically when the SuperFrost, function is activated, fresh food has just been placed in the appliance or the door has been left open for a while. u Solution: (see 1. 2) The SuperFrost button flashes together with the temperature display. The door of the appliance is not properly closed. [. . . ]