User manual LIEBHERR WT 4127

[. . . ] The appliance is not suited for storing and cooling pharmaceuticals, blood plasma, laboratory preparations or similar substances and products subject to the Medical Devices Directive 2007/47/EC. Any misuse of the appliance may result in damage to or spoilage of the stored goods. Range of appliance use Furthermore, the appliance is unsuited for use in areas exposed to an explosion hazard. Description of appliance and equipment WT 4126 WT 4127 Temperarure control Interior light switch Interior light Grid shelves Activated carchoal filter Type plate Adjustable- height feet 8 Adjustable- height feet · To prevent injury or damage to the unit, the appliance should be unpacked and set up by two people. · In the event that the appliance is damaged on delivery, contact the supplier immediately before connecting to the mains. · To guarantee safe operation, ensure that the appliance is set up and connected as described in these operating instructions. [. . . ] The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance. · Do not connect the appliance to the supply with other equipment using an extension cable - risk of overheating. Setting up GB Dimensions A=1644 mm Power supply (a. c. ) and voltage at the operating point must comply with the details on the type plate. The socket must be fused with a 10 A fuse or higher, it must be away from the rear of the appliance and must be easily accessible. Connect the appliance with a properly earthed fused plug and socket only. Connecting to the mains - Always ensure good ventilation. Do not cover ventilation openings or grille. - Do not place appliance in areas of direct sunlight or next to a stove, heater or similar object. - The energy consumption depends on the installation conditions, e. g. - Keep the time the appliance is open to a minimum. Saving energy Accumulated dust increases the energy consumption: - Once a year, dust the refrigerating unit together with the metal grille of the heat exchanger at the back of the appliance. To switch the appliance on: Connect the appliance to the mains - the appliance is switched on. You are recommended to clean the appliance before switching it on for the first time (see Cleaning). Switching the appliance on and off To switch the appliance off: Pull out the mains plug or set the temperature control to 0. Using a coin, turn the arrow on the temperature control to a setting between 0 und max. Setting 1 = lowest cooling setting Setting max. = highest cooling setting, cold Setting the temperature 9 If you change the setting on the temperature control, the temperature will only change in the bottom four compartments. If the temperature control is set higher (e. g. 1 - 1, 5), the lower compartments will become warmer. If the temperature control is set lower (3, 5 - max. ), the lower compartments will be cooler. The wine cooler enables you to bring your wines gradually and evenly to the right temperature for drinking in 6 different temperature zones. The table on the left indicates the temperature settings in each compartment, which are pre-set in the factory. The appliance is delivered with the grid shelves in the right positions to achieve these temperatures. Cooling wine The way in which wines continue to mature depends on the ambient conditions. The quality of the air is therefore decisive for preserving the wine. We recommend that you replace the filter once a year. Filters can be obtained from your dealer. Changing the filter: Take the filter by the handle. Turn it 90° to the left or right and remove. Inserting the filter: Insert with the handle in a vertical position. [. . . ] ­ Is the appliance set up too close to a heat source?If none of the above causes apply and you cannot rectify the fault yourself, contact the nearest customer service department stating the type of appliance 1, service number 2and appliance number 3as indicated on the type plate. The type plate is located in the refrigerator compartment on the left-hand side. Malfunctions Spread out the lava stones provided along the defrost water drain gulley along the bottom of the interior. Make sure the drain pipe in the middle is not blocked. [. . . ]