User manual LIEBHERR WTEES 2053 VINIDOR

[. . . ] Conformity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Saving energy. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . General safety information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Controls and displays. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Check installation dimensions: u At the top, move the door over the turn hinge Fig. u Re-engage the cover of the turn hinge Fig. 4 (6) and tighten it firmly (with 2 Nm). u Engage the soft stop mechanism with the ball journal. 3 (4) of the soft stop mechanism and slide it forwards. Fig. 18 6 Putting into operation u For 16 mm thick unit walls (568 mm wide recess): Press spacer Fig. For 19 mm thick unit walls (562 mm wide recess): the spacer is not needed. Push the appliance into the recess until the lower turn hinge Fig. 27 (17) abuts the end face of the unit wall. 27 (17) bears on the floor of the recess. u u Fig. If the appliance is transported again, the transit support has to be re-fitted: u Do not dispose of the transit support for the door. u Fold down the cover of the folding bracket Fig. 34 (30) to the ceiling of the unit from underneath using two screws Fig. u Check that all the screw fittings are tight. u Fasten 4. 7 Switching on the appliance u Press On/Off button Fig. w The temperature display and the alarm button flash until the set temperature is reached. 5 Control Fig. 33 5. 1 Brightness of the temperature display You can adjust the brightness of the temperature display to the light conditions of the room in which the appliance is installed. u At the bottom of the turn hinge Fig. 30 (17) again measure the distance (X) from the front edge of the unit side wall to the appliance. u Check whether the measurement made is the same all the way round, otherwise the door may not close properly. u Re-align unit and appliance, if necessary. For initial assembly: u Take the handle out of the packaging of the ceiling protection and fit it to the inside of the door with 4 screws Fig. 34 5. 1. 1 Adjusting the brightness The brightness is adjustable between h0 (no illumination) and h5 (maximum luminosity). [. . . ] → The appliance is not switched on. → The LED lighting is defective or the cover is damaged: u w u w u Fig. 37 Notify the customer service, specifying the fault, appliance designation Fig. This will help us to provide you with a faster and more accurate service. [. . . ]