User manual LIEBHERR ZKES 453 HUMIDOR

[. . . ] These climatic conditions allow the characteristic flavours of the cigar to unfold, the cigar will burn evenly and your enjoyment of the cigar and its taste will be enhanced. With the Liebherr cigar storage unit you can ensure constant humidity and a constant temperature - and control each one individually. Naturally Spanish cedarwood. The interior fittings of the Liebherr cigar storage unit are made of Spanish cedarwood. This top quality wood is used for the shelves and presentation boxes. Spanish cedarwood is used because it ensures an even climate inside the appliance, it helps the cigars to mature and its aroma enhances the unique flavour of exclusive cigars. 18 Inhalt Seite GB Setting up. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Pull out the front flap completely and fold upwards at a 90° angle. The appliance will take 24 hours to reach the correct level for storing cigars (temperature, humidity). The factory setting is +18°C and 70% humidity. To switch off Press the On/Off button for 3 seconds until the display goes dark. Setting the temperature To reduce the temperature Press the Down button. To increase the temperature Press the Up button. - While you are entering the temperature, the set temperature will flash on the display. - The electronic controls will switch over automatically about 5 seconds after the last time you pressed the button, and the interior temperature will be displayed. The temperature can be set between +16°C and +20°C. 22 Adjusting the humidity To reduce the humidity Press the Down button. To increase the humidity Press the Up button. GB - While you are setting the humidity, the display will flash. - About 5 seconds after the button was last pressed, the actual interior humidity will be displayed. The humidity can be adjusted between 68% and 75%. button. • Exit setup mode by pressing the Deactivating the child lock • Activate setup mode by pressing th - The display reads • Press the button. button for 5 seconds. - The display reads • Press the - The button again. symbol will go out, indicating that the child lock is deactivated. button. • Exit setup mode by pressing the 25 = Display brightness Adjusting the display brightness • Activate setup mode by pressing the • Press the Press the button until button. button for 5 seconds. appears in the display. - The display reads • Press the buttons and set the brightness between 0 = minimum and 5 = maximum. • When you reach the desired level, press the • Exit setup mode by pressing the button. The new setting will activate after about 1 minute. 26 Equipment Air exchange with activated charcoal filter To guarantee optimum air throughput, the appliance is fitted with an activated charcoal filter at the top of the rear wall. We recommend that you replace the illustrated filter once a year. Filters can be obtained from your dealer. Changing the filter: The filter can be removed by depressing the recesses on the left and right with a small screwdriver. Spanish cedarwood shelves The presentation boxes are designed for storing cigars individually. The other shelves are for storing cigars in various containers or boxes. All shelves are fitted with a pull-out stop and can be pulled out by 100 mm. To remove completely, pull the shelf out as far as it will go, lift slightly at the front and remove. [. . . ] It is very important for servicing purposes. 30 Malfunctions GB If a malfunction occurs during operation, check whether it is due to an operating error. Please note that even during the warranty period the resultant servicing costs in this case will have to be borne by the owner. • When disconnecting the appliance, pull on the plug, not on the cable. • Any repairs and work on the appliance should only be carried out by the customer service department, as unauthor­sed work could prove highly dangerous for the i user. [. . . ]