Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual LIFT-MASTER 1A4730. We hope that this LIFT-MASTER 1A4730 user guide will be useful to you.
Lastmanuals help download the user guide LIFT-MASTER 1A4730.
Detailed instructions for use are in the User's Guide.
[. . . ] RED/GREEN LIGHT CONTROL MODULE
For Use On Model APT
001A4730
Use with 1A4811 CPSII Option Board for Timer to Close Function Light Box/Door Operator Mounting
Commercial door operator accessory for use only with Liftmaster solid state commercial door operators.
®
WARNING
TO AVOID DAMAGE TO RELAYS, DO NOT EXCEED THE FOLLOWING: Red light - 75W, 120V incandescent bulb or 3A, 250VAC (Resistive load) Green light output - 75W, 120V incandescent bulb or 3A, 250VAC (Resistive load)
W
ING
WARNING
TO AVOID SERIOUS PERSONAL INJURY OR DEATH FROM ELECTROCUTION, DISCONNECT ELECTRICAL POWER TO OPERATOR BEFORE PROCEEDING.
CAUTION
Side View
APT Low-Profile Solid State Door Operator
ION
WARNING
STEP 3: Flex conduit to electrical box (use hole shown in figure 1).
STEP 1: Attach light box mounting bracket to frame (#10-12419). [. . . ] · Connect white wire to L1 (NEUTRAL) on the power terminal strip.
· Connect black jumper from L2 (HOT) on the power
terminal strip to (120V IN) terminal on the PCB connector. STEP 6: · Install red and green lights. STEP 7: · Refer to your Owner's Manual Optional Settings Section for Timer to Close programming procedure.
Light Control Module Operation:
The green lights on the Option Board will turn on if the board is seated properly and the power is on. When the door reaches the full open position, the timer circuit will be activated. The green lampholder will receive power. If the timer has not been set, the red lampholder will receive power when the door starts to close and until close limit is activated. If the timer has been set, the red lampholder will receive power as follows: TIMER SETTING Greater than 10 seconds Equal to 10 seconds Less than 10 seconds RED LAMPHOLDER RECEIVES POWER 10 seconds before door starts to close and until close limit is activated. 5 seconds before door starts to close and until close limit is activated. [. . . ] All Rights Reserved
LOAD
White Bla ck
3 GREEN LT.
D1
L2
White
X
d Re
2
+24VDC OUT
WARNING DEVICES BOARD
+24V +5V
RED LT. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE LIFT-MASTER 1A4730
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual LIFT-MASTER 1A4730 will begin.
