Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual LIFT-MASTER 300LM. We hope that this LIFT-MASTER 300LM user guide will be useful to you.
Lastmanuals help download the user guide LIFT-MASTER 300LM.
Detailed instructions for use are in the User's Guide.
[. . . ] When Installing two or more receivers in a garage, position them at least 10 feet apart to prevent electronic interference. NOTE: Models 300-1LM and 300-2LM are factory pre-set with matching receiver and transmitter codes. CAUTION: Do not attempt to open the receiver back panel THERE ARE NO USER SERVICEABLE PARTS.
_______________________________________________________________________________________________________
MOUNTING RECEIVER ON OPENER
Fully extend antenna wire below bottom of case as shown. [. . . ] Attach mounting clips to receiver terminals 1 and 2, and to the opener terminals used for push button controls. Plug the transformer Into the receiver as shown and into a 120 Volt outlet. Fully extend the antenna wire below bottom of case as shown. Fasten the receiver to an Inside garage wail with wood screws provided. A convenient place is alongside the service door and OUT OF THE REACH OF CHILDREN. Attach one end of 2-strand wire to receiver terminals 1 and 2. The other end must be connected to the two opener terminals which are used for the push button control. Use insulated staples to secure bell wire between receiver and opener. If it doesn't light and the opener has three terminals use a third strand of bell wire to connect receiver terminal 3 to the third opener terminal. If the receiver push bar still doesn't light, use Transformer Model 85. NOTE With transformer, use a 2-wire connection ONLY. Attach wire to receiver terminals 1 and 2 and to the opener terminals used for push button control. Plug transformer into receiver and 120 Volt outlet as shown.
Side 2 contains installation and service information as well as code setting instruction for models with transmitter(s).
THE TRANSMITTER The portable transmitter may be secured to a car sun visor with the clip provided. Additional transmitters can be purchased at any time for use in all vehicles using the garage. New transmitters must be set to the same code as original transmitter. The transmitter is equipped with a battery check light. When the push button is pressed, the light will glow if the battery has power (and the opener will operate). The 12 Volt battery should produce power for at least a year. [. . . ] Pry open the front panel of receiver case with a coin or screwdriver.
3. Press the "Smart" actuator on the receiver. The indicator light alongside will turn ON. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE LIFT-MASTER 300LM
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual LIFT-MASTER 300LM will begin.
