User manual LIFT-MASTER 320LM

[. . . ] THE RECEIVER MAY BE INSTALLED IN ONE OF TWO WAYS: 1. Mounted directly on the door opener with clips provided as described below. Attached to an inside wall of the garage with connecting bell wire (not supplied), described on side two. [. . . ] Leaving the push button bell wire in place, insert the other ends of the mounting clips under the opener terminal screws. If the number sequence of opener terminals doesn't match the receiver, turn the receiver around (so back is facing out) and complete the connection. NOTE: Terminals 1 and 2 on the receiver MUST be connected to the push button terminals on the opener. Retighten the terminal screws on the opener and receiver. If it doesn't light and your opener has a radio power terminal, use the third mounting clip to connect receiver terminal 3 to opener terminal 3. If the receiver push bar still doesn't light, you must use Transformer Model 85. Push Button To Outlet OPENER TERMINALS Receiver Terminals Flange Mounting Clip #3 Common Mounting Clip #2 Mounting Clip #1 © Model 85 Transformer Antenna Wire Fully Extended NOTE: With the transformer, use a 2 wire connection ONLY. Attach mounting clips to the receiver terminals 1 and 2, and to the opener terminals used for push button controls. Plug the transformer into the receiver as shown, and into a 120 Volt outlet. Side 2 contains installation and service information as well as code setting instruction for models with transmitter(s). MOUNTING RECEIVER ON GARAGE WALL Fully extend the antenna wire below bottom of case as shown. Fasten the receiver to an inside garage wall with the screws provided. A convenient place is alongside the service door and OUT OF THE REACH OF CHILDREN. Attached one end of 2-strand wire to receiver terminals 1 and 2. The other end must be connected to the two opener terminals which are used for the push button control. Use insulated staples to secure bell wire between receiver and opener. If it doesn't light and the opener has three terminals, use a third strand of bell wire to connect receiver terminal 3 to the third opener terminal. If the receiver push bar still doesn't light, use Transformer Model 85. NOTE: With the transformer, use a 2-wire connection ONLY. [. . . ] NOTE: If the remote control push button is not pressed within 30 seconds, receiver indicator light will turn OFF. To Erase All Transmitter Codes · Press and hold the "Smart" code button on the opener panel until the indicator light turns off (about 6 seconds). All the codes the opener has learned will be erased. [. . . ]