User manual LIFT-MASTER 530LM

[. . . ] In order to comply with both the letter and the spirit of these laws, this universal radio control should not be used with any Lift-Master®, Chamberlain®, or Sears Craftsman® garage door opener manufactured prior to April 1, 1982. To find out if your Chamberlain-made garage door opener was manufactured prior to or after April 1, 1982, please call 1-800-5289131 before installing this universal radio control. WARNING Disconnect power to the garage door opener before installing the receiver. Children operating or playing with a garage door opener can injure themselves and others. [. . . ] · If you have code switches, reset them to a random code and deactivate the receiver by removing the tuning slug and antenna. DOWN DOWN UP LIGHT DOWN DOWN RED WHT BLK YEL L3 UP Force DOWN Force + 123456789 0 - TP1 UP LIGHT RED WHT BLK YEL UP Force + 123456789 0 - DOWN Force 1984-1990L3 1000 Series L3 BLK YEL Cut L3 RED TP1 WHT L3 L3 UP Force Cut L3 DOWN Force 1990-1992 1100 Series Cut DOWN UP LIGHT TP1 RED WHT BLK YEL UP Force R44 DOWN Force R44 R44 1990-1992 1100 Series R44 TP1 UP LIGHT Cut R44 R44 RED TP1 WHT BLK YEL UP Force DOWN Force 1992 1100-4, 1200 Series R5 DOWN UP LIGHT The receiver may be installed in one of two ways: 1. Mounted directly on the door opener with clips provided as shown on page one. Attached to an inside wall of the garage with connecting bell wire (not supplied) as shown on page two. When installing two or more receivers in a garage, position them at least 10 feet apart to prevent electronic interference. MOUNTING ON RESIDENTIAL OPENERS Fully extend antenna wire below bottom of case as shown in Figure 2. Attach mounting clips to receiver terminals 1 and 2, and to the opener terminals used for push button controls. Plug the transformer into the receiver as shown, and into a 120 Volt outlet. Page two contains wall mounting instructions and service information as well as code setting instructions. Figure 1 TP1 R5 Cut R5 To Outlet OPENER TERMINALS Receiver Terminals Flange Mounting Clip #3 Radio Power Push Button Common Mounting Clip #2 Mounting Clip #1 © Model 85 Transformer Figure 2 Antenna Wire Fully Extended MOUNTING RECEIVER ON GARAGE WALL Fully extend the antenna wire below bottom of case. Fasten the receiver to an inside garage wall with dry wall screws provided. A convenient place is alongside the service door and OUT OF THE REACH OF CHILDREN. Attach one end of 3-strand bell wire (not supplied) to receiver terminals 1, 2 and 3. Connect the other end to the three opener terminals used for push button controls and radio power. Use insulated staples to secure bell wire between receiver and opener. If it does not, use Transformer Model 85. NOTE: With the transformer, use a 2-wire connection only. Attach wire to receiver terminals 1 and 2 and to the opener terminals used for push button control. [. . . ] With the jumper in the "MOM" (Momentary) position, the contacts will close for 1/4 second regardless of the length of radio transmission. With the jumper in "CONST" (Constant) position, the contacts will stay closed as long as the radio continues transmitting. The receiver is factory set at M. MO CONS M. [. . . ]