User manual LIFT-MASTER 65 9207

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual LIFT-MASTER 65 9207. We hope that this LIFT-MASTER 65 9207 user guide will be useful to you.

Lastmanuals help download the user guide LIFT-MASTER 65 9207.

Download

Manual abstract: user guide LIFT-MASTER 65 9207

Detailed instructions for use are in the User's Guide.

 [. . . ] AUXILIARY TROLLEY MODIFICATION
659207-XX and 6592071-XX For Use With Models J,  H and GH
NOTE: XX is door height. 

APPLICATION
This modification is available for model J,  H and GH operators. For 1/2 HP and lower side mount operators use #48 drive chain. For 3/4 HP and higher side mount operators use #41 drive chain.  [. . . ] Install a track spacer in the idler assembly,  this keeps the track properly spaced. Slide the slider assembly into the track with the take-up bolt towards the open end. At the open end of track install the idler assembly that is normally the front idler on a trolley operator. Install the chain,  use the take-up bolt to adjust the chain tension to allow about 3" sag in the center (remove links if necessary). Install the track and brace appropriately. 1

FIGURE 1

Front Idler Assembly

Track Spacer

Connect the Shaft From the Front Idler Assembly to the Extension Shaft by Coupling Two 48B12 Sprockets Together With #40 Chain and Masterlink. 

Extension Shaft

INSTALL THE OPERATOR
1. Install the operator using the appropriate installation manual. Remove the 50B12 output sprocket from the operator and install the new 50B35 sprocket on the operator. The 50B12 sprocket will be installed on the extension shaft. 

INSTALL EXTENSION SHAFT
1. Determine the length of the extension shaft to be used and cut it to this length. Install the 48B14 sprocket provided on the end of the shaft by drilling a 1/4" hole through the sprocket and shaft and pinning with the 1/4" by 1-1/2" roll pin provided. Be sure that the shaft does not extend past the end of the sprocket and that the teeth of the sprocket are at the end of the shaft (Figure 2). Couple the shaft to the front idler assembly by butting the two 14 tooth sprockets together and coupling them with the #40 chain and master link (Figure 1). Install the new bearing assemblies on the extension shaft.  [. . . ] Bearing assembly should be mounted as close to the (50B12) sprocket as possible to prevent shaft flex. Refer to owner's manual for reversing limits. 

Disconnect Bracket

01-12574F

© 2005,  The Chamberlain Group,  Inc. All Rights Reserved

Printed in Mexico [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE LIFT-MASTER 65 9207

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual LIFT-MASTER 65 9207 will begin.