User manual LIFT-MASTER 92LM

[. . . ] Model 92LM Security& 2-Channel Remote Control OWNER'S MANUAL NOTICE: To comply with FCC rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. WARNING Children operating or playing with a garage door opener can injure themselves or others. The garage door could close and cause serious injury or death. [. . . ] Instructions are described and illustrated below. WHEN USED WITH SECURITY& GARAGE DOOR OPENERS To program the opener to accept the remote control code: 1. Press and hold the smooth remote control push button. Press and release the "Smart" (learn) button on the opener panel. The indicator light on the panel will begin to blink and the opener lights will flash once. Now the opener will operate when the smooth push button is pressed. Adding a remote can also be done from the door control, as follows: 1. With the door closed, press and hold the smooth push button. Press and hold the Light button on the door control. Press and hold the door control push bar. After the opener lights flash, release all buttons. Test by pressing the smooth remote push button. TO ERASE ALL REMOTE CONTROL CODES FROM THE RECEIVER Press and hold the "Smart" button on the opener panel until the indicator light turns off (about 6 seconds). All transmitter codes inside the receiver are now erased. [. . . ] This code will remain inside the remote control until replaced with a new code by repeating the above steps. AVERTISSEMENT Replacement Parts Model 92LM Security& remote case, cover, screw (circuit board not included) . . 29C128 FOR SERVICE DIAL OUR TOLL FREE NUMBER: 1-800-528-9131 114A2170 © 1997, Chamberlain Group Inc. All Rights Reserved Printed in Mexico [. . . ]