User manual LIFT-MASTER 940D

[. . . ] During that time the Enter button can be used to stop or reverse the door travel. ® / Model 940D Security® Wireless Keyless Entry WARNING To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door: · ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote control transmitters. · Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel. · ALWAYS keep gate or garage door in sight until completely closed. [. . . ] Within 30 seconds, enter a four digit personal identification number (PIN) of your choice on the keypad. Release the button when the motor unit lights blink. If light bulbs are not installed, two clicks will be heard. LOCK LIGHT LOCK LIGHT Side two contains instructions for installing the Keyless Entry, changing the personal entry password and setting a temporary password. 1 INSTALLATION Keyless Typical TO CHANGE AN EXISTING, KNOWN PIN If the existing PIN is known, it may be changed by one person without using a ladder. Press the four buttons for the present PIN, then press and hold the # button. Press the new 4-digit PIN you have chosen, then press ENTER. The motor unit lights will blink once when the PIN has been learned. Test by pressing the new PIN, then press ENTER. The door should move. Entry Installation Choose a convenient location for installation. Exterior Front Wall It should be at eye 1-Piece or level, reachable by the Sectional Door shortest person who will Door Jamb Edge use it, and within sight (Optional) of the door. Door Jamb Face For a one-piece door, (SECTIONAL DOOR ONLY) choose the optional KEYLESS ENTRY MUST BE location shown in the INSTALLED WITHIN illustration to avoid SIGHT OF THE DOOR injury as the door swings up and out. Test the reception of the Keyless Entry by operating your opener from the selected location. Remove the battery compartment Bottom cover to access the bottom mounting hole mounting hole: · Insert a small phillips screw driver Battery into the small hole at the bottom of Battery the cover and gently pull outward to Cover loosen. · Slide the cover down to remove. Center the keypad at eye level against the selected location. Mark 4-1/4" (10. 6 cm) up the centerline from the bottom and drill a 1/8" pilot hole. Install top mounting screw, allowing 1/8" (3 mm) to protrude above surface. Position keypad on screw head and adjust for snug fit. With cover open so bottom mounting hole is visible, use a punch to mark hole. Remove keypad and drill 1/8" pilot hole. Replace keypad and complete installation with bottom screw, using care to avoid cracking plastic housing. [. . . ] SPECIAL NOTE: The temporary password can ONLY be programmed to keypads working on a Chamberlain, Craftsman® or LiftMaster Garage Door Opener. It WILL NOT work on keypads programmed to an external receiver. THE KEYLESS ENTRY BATTERY WARNING To prevent possible SERIOUS INJURY or DEATH: · NEVER allow small children near batteries. · If battery is swallowed, immediately notify doctor. The 9 volt battery should produce power for at least one year. [. . . ]