User manual LIFT-MASTER 973TB

[. . . ] Security® 3-Button Remote Control OWNER'S MANUAL Models: 973TB · 973TS · 973TC · 973TT The 900 Series remote control works only with door openers and light controls having an orange "Learn" button. Programming instructions are described and illustrated below. The additional push buttons can also activate other garage door openers and/or light controls. [. . . ] If light bulbs are not installed, two clicks will be heard. Your Security® remote control can be programmed to operate one door using all 3 buttons: the large button will only open the door, the middle button will close the door, and the third button will stop the door's movement. You may set up this feature as follows: 1. With the door closed, press and hold the large remote push button. Press and hold the Lock button on the Close door control. Press and hold the door control push bar. When the opener lights flash, release all buttons. Test by pressing the large (Open) button on the remote. Press it again while the door is open and nothing should happen. Press the middle (Close) button while the door is moving and it should close. Press the third (Stop) button and the door should stop immediately. To Erase All Codes From Motor Unit Memory To deactivate any unwanted remote, first erase all codes. Press and hold the "learn" button on motor unit until the learn indicator light goes out (approximately 6 seconds). Reprogram each remote or keyless entry you wish to use. To Control the Opener Lights With Security® transmitters, a remote push button can be programmed to operate the opener lights without opening the door. With the door closed, press and hold the remote button that you want to control the light. Press and hold the Light button on the door control. Press and hold the Lock button on the door control. After the opener lights flash, release all buttons. [. . . ] . 29B137 Owner's manual - Spanish: . . 114A2738SP © 2004, Chamberlain Group Inc. All Rights Reserved Printed in Mexico [. . . ]