User manual LIFT-MASTER 982LM

[. . . ] WARNING Model 982LM Security& Plug-In Light Control OWNER'S INSTRUCTIONS To comply with FCC rules, adjustment or modification of receiver and/or transmitter is prohibited, except for changing the code setting and replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. The Light Control is for indoor use only. [. . . ] Follow the instructions below: · Select a remote control push button to operate the light control. Select a push button Actuator Power Indicator Light Smart Indicator Light Smart (Learn) Button 120VAC Polarized Wall Outlet · Pry up the lower edge of the actuator with a coin or screwdriver as shown. · Plug the light control into a 120 Vac polarized outlet. The plug contacts are designed for polarized outlets only. The power indicator light will turn on if there is power to the outlet. · Press and hold the remote control push button you chose to activate the light control. · Then press and release the "Smart" (learn) button on the receiver with a pen or pencil tip. The adjacent yellow indicator light will FLASH once. · Release the remote control push button. Snap actuator back on light control. The remote control push button must be held down until the receiver indicator light flashes for the light control to learn the remote control's code. If the receiver SMART button is pressed and held until the yellow indicator light alongside goes out (in about 6 seconds), all memorized codes will be erased. OPERATING INSTRUCTIONS If two or more light products are installed, the receivers must be located at least 10 feet apart to prevent electronic interference. · First, plug the lamp into a wall outlet and turn it ON. [. . . ] Refer to the remote control instructions for battery changing information. FOR SERVICE DIAL OUR TOLL FREE NUMBER: 1-800-528-2817 114A2364B © 2000, The Chamberlain Group, Inc. All Rights Reserved Printed in Mexico [. . . ]