User manual LIFT-MASTER ACRX 1000

[. . . ] TM Access Control Receiver ACRx Model 1000 OWNERS MANUAL ACCESS CONTROL To comply with FCC/IC rules, adjustment or modification of receiver and/or transmitter is prohibited, except for changing the code setting and replacing the transmitter battery. THERE ARE NO USER SERVICEABLE PARTS. ACRx1000 RECEIVER TM exit WARNING Disconnect power to the garage door or gate opener before installing the receiver. Children operating or playing with a garage door or gate opener can injure themselves and others. The garage door or gate could close and cause serious injury or death. [. . . ] Press ENTER one more time and the date is set. "Set the DATE" will be displayed again. Press SETUP/EXIT to return to the regular display. Set RELAY Mode: The method of relay operation depends on the type of gate or door opener the ACRx is controlling. The three types of operating modes are described as follows: · Momentary Close: The relay contacts will close for 1/3 seconds each time a valid user's transmitter code is received. This is the factory default state of the ACRx, and the most commonly used. · On When Receiving: The relay contacts will close when a valid transmitter code is received, and remain closed until the user releases his transmitter button. · Toggle ON/OFF: The relay contacts will close when a valid transmitter code is received, and remain closed until the next one is received. The relay will continue to toggle ON/OFF in this manner for each valid code received. This mode is useful when the relay must stay on after the user releases his transmitter button. Add User The display will show "DELETE <USER ID>?" Press ENTER to delete that User ID, or EXIT to cancel and start over. After ENTER is pressed, the display will flash "Del Usr COMPLETE". When a User ID is deleted, the ACRx will no longer respond to that transmitter and all record of that user is deleted from the ACRx. Block and Unblock Users Press the BLOCK USER button. The display will show "USER ID = _____". Turn the knob until the first letter of the User ID is shown, then press ENTER. Repeat until the entire User ID is displayed. The display will show "BLOCK <USER ID>?" Press ENTER to temporarily block that User ID, or EXIT to cancel and start over. When a User ID is blocked, the ACRx will display the attempted entry as "BLOCKED:_____", and will not open the gate. Time and date of the attempted entry is available at the computer serial port. To unblock a user, press the BLOCK USER button and repeat the steps used to choose the User ID. The display will show "UNBLOCK <USER ID>?" Press ENTER to unblock that user, or EXIT to cancel and leave the user blocked. TRANSMITTER/WIRELESS OPERATION Each 80 series "Billion Code" transmitter is uniquely coded at the factory; no two transmitters have the same code. When adding a user there is no need to program the transmitter or set code switches. If using 60 series (or older) transmitters, each transmitter should have a different code setting. [. . . ] Instead of selecting a custom User ID, the ACRx can choose a number. Simply press ENTER 5 times when "USER ID __" is displayed (enter a User ID of all blanks), and the next hour/minute/second/AM-PM format. Turn the dial until that digit is set, then press ENTER. Press ENTER once more and the time is set. [. . . ]