Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual LINE 6 FLOOR BOARD. We hope that this LINE 6 FLOOR BOARD user guide will be useful to you.
Lastmanuals help download the user guide LINE 6 FLOOR BOARD.
Detailed instructions for use are in the User's Guide.
[. . . ] If you own an AX2 or AxSys, you will find that the Floor Board is sized to fit into the back of the amp, and if you put it in with the pedals and buttons facing toward the back of the amp, the speaker magnets will hold on to the Floor Board's flat steel bottom panel.
Getting Connected
The Floor Board is designed exclusively for use with Line 6 Digital Guitar Amplifier Systems. Do not attempt to connect the Floor Board to any other product. [. . . ] Press any switch (including this one) to exit tuner mode. The red lights above the six lower stomp switches show if you are sharp or flat, and the display shows which note you are tuning to. The basic idea is that the lights to the left glow if you're flat, and the lights to the right glow if you're sharp. When you get a note in tune, the two center lights will be lit up at the same time. See your Digital Guitar Amplifier System's manual for more details on tuning.
Volume Pedal
The volume pedal gives you foot control over the volume of your Channels. With an AX2 or AxSys, a Channel can be programmed to respond to the volume pedal before or after the guitar signal reaches the preamp section. If the volume pedal doesn't seem to be affecting the volume of your Channel as you would like it to, you probably have to change the Channel's settings for the volume pedal on the AX2. The volume pedal will have no effect if a Channel's Volume Pedal On/Off setting is "OFF" on the Comp/Pedals row of the Edit Matrix. See your Digital Guitar Amplifier System's manual for details on volume pedal operation.
Wah Pedal
The wah pedal has an on/off switch under the toe of the pedal. Press down on the toe of the pedal to turn the wah effect on or off. [. . . ] Be sure to note that if you store a Channel after you've turned effects on and off, the new setup of effects will be stored with that Channel. Your stored Channels will not be affected if you turn some effects on or off with these switches, but then do not store the changes before selecting a new Channel. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE LINE 6 FLOOR BOARD
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual LINE 6 FLOOR BOARD will begin.
