User manual LINKSYS BEFVP41

[. . . ] USER GUIDE EtherFast® Cable/DSL VPN Router with 4-Port Switch Model: BEFVP41 (EU/LA) About This Guide About This Guide Icon Descriptions While reading through the User Guide you may see various icons that call attention to specific items. Below is a description of these icons: NOTE: This check mark indicates that there is a note of interest and is something that you should pay special attention to while using the product. WARNING: This exclamation point indicates that there is a caution or warning and it is something that could damage your property or product. WEB: This globe icon indicates a noteworthy website address or e-mail address. Online Resources Website addresses in this document are listed without http:// in front of the address because most current web browsers do not require it. If you use an older web browser, you may have to add http:// in front of the web address. Resource Linksys Linksys International Support Glossary Network Security Website www. linksys. com www. linksys. com/eu or www. linksys. com/latam www. linksys. com/support www. linksys. com/glossary www. linksys. com/security Copyright and Trademarks Linksys, EtherFast, Cisco, and the Cisco Logo are registered trademarks or trademarks of Cisco Systems, Inc. [. . . ] Open the web browser (for example, Internet Explorer or Firefox), and enter the Router's IP address in the address field (the default IP address is 192. 168. 1. 1). When prompted, leave the User name field blank and enter the password to the Router (the default is admin). Click the appropriate tab to change the settings. · Check the cable connections. The computer should be connected to one of the ports numbered 1-4 on the Router, and the modem must be connected to the Internet port on the Router. The modem does not have an Ethernet port. The modem is a dial-up modem for traditional dial-up service. To use the Router, you need a cable/DSL modem and high-speed Internet connection. You cannot use the DSL service to connect manually to the Internet. After you have installed the Router, it will automatically connect to your Internet Service Provider (ISP), so you no longer need to connect manually. The DSL telephone line does not fit into the Router's Internet port. You still need your DSL modem in order to use the Router. Connect the telephone line to the DSL modem, insert the setup CD into your computer, and then follow the on-screen instructions. WEB: If your questions are not addressed here, refer to the Linksys website, www. linksys. com. EtherFast Cable/DSL VPN Router with 4-Port Switch 20 Appendix B VPN Tunnel Appendix B: VPN Tunnel Overview This appendix describes an example of how to set up a VPN tunnel between two VPN Routers. Refer to "Chapter 3: Advanced Configuration" for more information. Instructions 1. Open your web browser, and enter 192. 168. 1. 1 in the Address field. On the login screen, enter the password you have set up for the Router (the default is admin). For the Select Tunnel Entry setting, select an entry number. For the VPN Tunnel setting, select Enable. This name should be unique for this particular tunnel. For the Local Secure Group setting, select Subnet. Then complete the IP and Mask fields (refer to your local network's IP address scheme). For the Remote Secure Group setting, select IP Addr. Then enter the IP address of the remote computer on the other end of the tunnel. For the Remote Security Gateway setting, select IP Addr. [. . . ] The following conditions apply to all code found in this distribution, be it the RC4, RSA, lhash, DES, etc. , code; not just the SSL code. The SSL documentation included with this distribution is covered by the same copyright terms except that the holder is Tim Hudson (tjh@cryptsoft. Copyright remains Eric Young's, and as such any Copyright notices in the code are not to be removed. If this package is used in a product, Eric Young should be given attribution as the author of the parts of the library used. [. . . ]