User manual LINKSYS EFROU44

[. . . ] EtherFast® Series. EtherFast 10/100 4-Port Analog Router User Guide COPYRIGHT & TRADEMARKS Copyright © 1999 Linksys, All Rights Reserved. EtherFast is a registered trademark of Linksys. Microsoft, Windows, and the Windows logo are registered trademarks of Microsoft Corporation. All other trademarks and brand names are the property of their respective proprietors. [. . . ] If you are in doubt, just leave it blank or consult the user manual of the connected modem. For Modem Speed, in most cases, Auto will work with most 56K modems (K56flex, X2 or V . 90). However, for some slow speed modems (28. 8K, 14. 4K, 9600), you might need to manually select a lower speed (e. g. You might achieve the highest possible speed by testing it in step 13 later. On the Main menu, click on Connection Profiles under the Configure Access heading. See a picture of the screen on the next page. 16 9. If you had previously set up a profile, highlight New and click Next. For Profile Name, enter the name of your ISP or any other name that makes sense to you. For Remote Phone Number, enter the phone number of your ISP. For My System Name, enter your username assigned by your ISP. For My System Password, enter the password for your ISP account. Use the pull down menu to select a connected modem port for the Analog Router to use when testing the account information and connection. The Message Window will tell you if your connection is successful. Follow step 5 to step 13 above to setup all the other modems and ISP accounts, if any. 17 Using the Router Status Windows Current Status This window pops up in a seperate browser window every time you log on to the router. This window can be closed or reduced if you don't need it. It displays the number of packets sent or received by the LAN and the modem(s). These numbers can be reset by highlighting the option and clicking on the Clear button. If you highlight a modem connection and click on Disconnect, that particular connection will be reset. Disconnecting a modem will drop one of your Internet connections. 18 Connection Log This window displays log of the connections. This window is used mainly for troubleshooting and administration purposes. Message Window This window displays any messages sent by the router to the system. It will display error messages, command strings, and general connection status information. You will notice that the user interface for the EtherFast 10/100 4-Port Analog Router utilizes frames. On the right hand side of your screen, the message window occupies the lower frame. [. . . ] You can configure the router to allow mulitple user dial-up access or single-user dial-up access. Multi-user Single User 37 Troubleshooting My modem doesn't dial out: · Check the cable connection and wiring. My modem dials out but a connection can't be established with the ISP: · See the error message that appears in the message window. If it is related to password authentication, check your user name and password. [. . . ]