User manual LINKSYS HG200

[. . . ] 2, 4 GHz Home Wireless-G 802. 11g Gateway WIRELESS User Guide Model No. HG200 Home Wireless-G Gateway Copyright and Trademarks Specifications are subject to change without notice. Linksys is a registered trademark or trademark of Cisco Systems, Inc. Copyright © 2005 Cisco Systems, Inc. Other brands and product names are trademarks or registered trademarks of their respective holders. How to Use this Guide Your Guide to the Home Wireless-G Gateway has been designed to make understanding networking with the Gateway easier than ever. [. . . ] Click the Wireless Clients Connected button to view a list of the wireless clients connected to the Gateway, along with their computer names, IP addresses, and MAC addresses. Click the Refresh button if you want to refresh the displayed information. Click the Close button to return to the Wireless screen. Click the Refresh button if you want to refresh the displayed information. Figure 5-45: Wireless Figure 5-46: Networked Computers Chapter 5: Configuring the Home Wireless-G Gateway The Status Tab 45 Home Wireless-G Gateway The DSL Connection Tab This screen shows information about the DSL connection and the PVC connection. DSL Status This section shows the following: DSL Status, DSL Modulation Mode, DSL Path Mode, Downstream Rate, Upstream Rate, Downstream Margin, Upstream Margin, Downstream Line Attenuation, Upstream Line Attenuation, Downstream Transmit Power, and Upstream Transmit Power. PVC Connection After you select the PVC connection number from the drop-down menu, you see the following information: Encapsulation, Multiplexing, QoS, Pcr Rate, Scr Rate, Autodetect, VPI, VCI, Enable status, and PVC Status. Click the Refresh button if you want to refresh the displayed information. Figure 5-47: DSL Connection Chapter 5: Configuring the Home Wireless-G Gateway The Status Tab 46 Home Wireless-G Gateway Appendix A: Troubleshooting This appendix consists of two parts: "Common Problems and Solutions" and "Frequently Asked Questions. " Provided are possible solutions to problems that may occur during the installation and operation of the Gateway. Read the descriptions below to help you solve your problems. If you can't find an answer here, check the Linksys international website at www. linksys. com/international. Common Problems and Solutions 1. I need to set a static IP address on a computer. You can assign a static IP address to a computer by performing the following steps: · For Windows 98 and Me: 1. Click Start, Settings, and Control Panel. In The following network components are installed box, select the TCP/IP-> associated with your Ethernet adapter. If you only have one Ethernet adapter installed, you will only see one TCP/IP line with no association to an Ethernet adapter. Highlight it and click the Properties button. In the TCP/IP properties window, select the IP address tab, and select Specify an IP address. Enter a unique IP address that is not used by any other computer on the network connected to the Gateway. Make sure that each IP address is unique for each computer or network device. Click the Gateway tab, and in the New Gateway prompt, enter 192. 168. 1. 1, which is the default IP address of the Gateway. Click the Add button to accept the entry. Click the DNS tab, and make sure the DNS Enabled option is selected. Enter the Host and Domain names (e. g. , John for Host and home for Domain). Enter the DNS entry provided by your ISP. If your ISP has not provided the DNS IP address, contact your ISP to get that information or go to its website for the information. [. . . ] This limited warranty extends only to the original purchaser. If the Product proves defective during the Warranty Period call Linksys Technical Support in order to obtain a Return Authorization Number, if applicable. BE SURE TO HAVE YOUR PROOF OF PURCHASE ON HAND WHEN CALLING. If You are requested to return the Product, mark the Return Authorization Number clearly on the outside of the package and include a copy of your original proof of purchase. [. . . ]