User manual LINKSYS PCMPC200

[. . . ] Instant EtherFast® Series EtherFast® 10/100 CardBus PC Cards Use this guide to install these Linksys Products: Linksys EtherFast 10/100 CardBus PC Card (PCMPC200 v2) Linksys EtherFast 10/100 Integrated CardBus PC Card (PCM200 v2) User Guide COPYRIGHT & TRADEMARKS Copyright © 2000 Linksys, All Rights Reserved. EtherFast is a registered trademark of Linksys. Microsoft, Windows, and the Windows logo are registered trademarks of Microsoft Corporation. All other trademarks and brand names are the property of their respective proprietors. [. . . ] Select the EtherFast 10/100 CardBusPC Card II, click on the Have Disk button. Insert the Driver Disk into the floppy drive. Type "a:\" into the box on your screen and hit OK. 5. When the following window appears, select Linksys EtherFast 10/100 CardBus PC Card Adapter II, click OK. · If you see this message, click Yes to install NT networking along with the EtherFast Card's network driver, and continue with step 1 below. · If you don't see this message, NT networking is already installed. Installing NT Networking & the EtherFast Card Driver 1. After clicking on Yes, the Network Setup Wizard window will appear. Put a checkmark next to the Wired to the network option. Click Next. 24 25 Linksys Instant EtherFast® Series EtherFast® 10/100 CardBus PC Cards 6. The adapter will be added to the list of installed Network Adapters. Click Next to approve these services, followed by Next again. 7. Place check marks beside each listed network protocol that you wish to install. See your Microsoft Windows NT user guide or talk to your network administrator for more information about network protocols. When you're finished, click Next. Note: If you install the TCP/IP protocol, refer to your system administrator or your Windows NT documentation when installation steps that aren't listed in this User Guide appear. Linksys does not provide technical support for the configuration or troubleshooting of the TCP/IP protocol. 9. NT will probably ask you to supply your original Windows NT CD-ROM or setup disks. If so, place your Windows NT CD-ROM in your CD drive. If the CD-ROM loads a pop-up window, close it. Type "D:\i386" (or the appropriate CD-ROM drive letter) in the box and click Continue. 10. NT will then display a window containing several setting types. Keep the default settings unless you know that you need to change them. After you have made the appropriate settings, click OK. 26 27 Linksys Instant EtherFast® Series EtherFast® 10/100 CardBus PC Cards 11. NT will copy the necessary network drivers to your PC. [. . . ] Do not reboot until after you have finished installing all desired components. Linux, Open Source and Beta Operating Systems Linksys does not provide technical support for Linux, BSD, or other freeware, Beta, or open source operating systems. Although many Linksys products have been proven to perform well under Linux and other freeware OSes, technical support for setup and troubleshooting is not provided. For information on where to find device drivers and setup instructions for Linux and other freeware OSes, visit the support pages and FAQ files on the Linksys website at www. linksys. com. 46 47 Linksys Instant EtherFast® Series EtherFast® 10/100 CardBus PC Cards Twisted-Pair Cabling There are different grades, or categories, of twisted-pair cabling. Category 5 is the most reliable and is highly recommended. [. . . ]