User manual LINKSYS RE7000

[. . . ] 24 You cannot get your range extender connected . 24 You cannot access your range extender. 24 You have intermittent connection problems . 27 2 Product Overview Front view The indicator LED on the front of the range extender gives you information about power, updating and signal strength. [. . . ] setting up as wired range extender (access point) Browser-based setup 1. Prepare for setup Be sure your router has a working Internet connection and you have an Ethernet cable long enough to connect the router to the range extender. Plug the Linksys extender into a wall outlet. Wait for the blinking indicator LED to change from green to amber. Use an Ethernet cable to connect the range extender to the LAN port of your router. On a computer, phone, or tablet, connect to the Wi-Fi network Linksys Extender Setup – XXX, where XXX are the last 3 digits of your range extender’s MAC address. Be sure to choose “As a wired range extender (access point)” when asked how you want to use your range extender. Follow the on-screen instructions to create a network name and password for your access point. Connect your Wi-Fi devices to the extended network you just created. Select the extended network on your device's Wi-Fi manager. Extended networks are identified by "_Ext" added to the end of your main network name(s). Note—If your router’s MAC filtering feature is on you must enter the MAC address of the extender into the list of the router’s allowed addresses. That will allow the extender, and devices connected to extended networks, to connect to the main network. The MAC addresses of the extender’s 2. 4GHz and 5GHz radios are identified as Seen By Upstream AP in the Status > WLAN Statistics screen. The MAC address of the extender’s Ethernet port is identified as Extender Mac Address on the Status > Device Info screen. Once the extender can access the router, all devices connected to the extender have access as well. 15 16 How to Access the Settings Interface To change or view range extender settings, first connect to an extended network, e. It is highly recommended that you change this after WPS setup. To change your admin password, click the Management tab of the settings interface and enter a new password under Extender Access. If you have not changed the range extender’s default name, you can also access the settings interface when connected to your main router. Note—XXX are the last 3 digits of your range extender’s MAC address. [. . . ] Com/support/RE7000 for prisbelønnet teknisk support døgnet rundt alle ugens dage. Følg anvisningene på skjermen for å lage et nettverksnavn og passord for tilgangspunktet. For dual-band nettverk, sørg for at du kobler til begge bånd, 2, 4 GHz og 5 GHz. Sørg for at du har minst 50 % av ruterens Wi-Fi-signal hvor du brukte enheten for oppsett. [. . . ]