User manual LINKSYS WPS54GU2

[. . . ] ® A Division of Cisco Systems, Inc. 2. 4 GHz Wireless-G 802. 11g PrintServer for USB 2. 0 WIRELESS Model No. User Guide WPS54GU2 Wireless-G PrintServer for USB 2. 0 Copyright and Trademarks Specifications are subject to change without notice. Linksys is a registered trademark or trademark of Cisco Systems, Inc. Copyright © 2003 Cisco Systems, Inc. Other brands and product names are trademarks or registered trademarks of their respective holders. How to Use this User Guide This User Guide has been designed to make understanding networking with the PrintServer easier than ever. [. . . ] When finished making your changes on this tab, click the OK button to save these changes, or click the Cancel button to undo your changes. For more information, click the Help button. Figure 7-16: Configuration - Internet Printing Chapter 8: Bi-Admin Management The Bi-Admin Management Utility 37 Wireless-G PrintServer for USB 2. 0 Port (Figure 8-17) · Physical Port. Select the number of the Selected Physical Port from the drop-down menu. Select the Handshake Signal, Busy Only or Busy & Ack. Select the Printer Type, High Speed or Low Speed. Select the Selected Logical Port from the drop-down menu and then the physical port you want to map it to from the drop-down menu for Map to Physical Port. If you select Yes for Convert LF to LF+CR, the LF (line feed) characters are changed to LF+CR (line feed + carriage return). In the field for Prefix of Job, enter the printer control string (in hexadecimal characters) to be sent to the printer before each print job. This string cannot exceed 30 characters. In the field for Suffix of Job, enter the printer control string (in hexadecimal characters) to be sent to the printer after each print job. This string cannot exceed 30 characters. Click the Get Defaults button if you want to cancel your changes and use the default settings. When finished making your changes on this tab, click the OK button to save these changes, or click the Cancel button to undo your changes. For more information, click the Help button. Figure 7-17: Configuration - Port Chapter 8: Bi-Admin Management The Bi-Admin Management Utility 38 Wireless-G PrintServer for USB 2. 0 Wireless (Figure 8-18) · SSID (Service Set Identifier). In the SSID field, enter the name of your wireless network. This is the unique name shared by all devices in a wireless network. The SSID is case-sensitive and should have 32 characters or fewer. If your network is set to ad-hoc mode, select your network's channel setting from the Channel No. The Network Type setting shows a choice of two wireless modes. Select Infrastructure if you want the PrintServer to communicate using an access point or wireless router. Select Ad-Hoc if you want the PrintServer to communicate without using an access point or wireless router. If you want to enable WEP encryption for greater wireless security, click the Enable radio button. [. . . ] The use of this device in a system operating either partially or completely outdoors may require the user to obtain a license for the system according to the Canadian regulations. EC DECLARATION OF CONFORMITY (EUROPE) Linksys declares that the Wireless-G PrintServer for USB 2. 0 conforms to the specifications listed below, following the provisions of the European R&TTE directive 1999/5/EC: For 2. 4 GHz devices with 100 mW radios, the following standards were applied: · EN 301 489-1, 301 489-17 General EMC requirements for Radio equipment. · EN 609 50 Safety · ETS 300-328-2 Technical requirements for Radio equipment. Caution: This equipment is intended to be used in all EU and EFTA countries. [. . . ]