User manual LINKSYS WRT54GR

[. . . ] ® A Division of Cisco Systems, Inc. 2. 4 GHz Wireless-G 802. 11g WIRELESS Broadband Router with RangeBooster User Guide Model No. WRT54GR Wireless-G Broadband Router with RangeBooster Copyright and Trademarks Specifications are subject to change without notice. Linksys is a registered trademark or trademark of Cisco Systems, Inc. Copyright © 2006 Cisco Systems, Inc. Other brands and product names are trademarks or registered trademarks of their respective holders. [. . . ] Make sure the security level is Medium or lower. I need to set a static IP address on a PC. You can assign a static IP address to a PC by performing the following steps: · For Windows 98SE and Me: 1. Click Start, Settings, and Control Panel. In The following network components are installed box, select the TCP/IP-> associated with your Ethernet adapter. If you only have one Ethernet adapter installed, you will only see one TCP/IP line with no association to an Ethernet adapter. Highlight it and click the Properties button. In the TCP/IP properties window, select the IP address tab, and select Specify an IP address. Enter a unique IP address that is not used by any other computer on the network connected to the Router. Make sure that each IP address is unique for each PC or network device. Click the Gateway tab, and in the New Gateway prompt, enter 192. 168. 1. 1, which is the default IP address of the Router. Click the Add button to accept the entry. Click the DNS tab, and make sure the DNS Enabled option is selected. Enter the Host and Domain names (e. g. , John for Host and home for Domain). Enter the DNS entry provided by your ISP. If your ISP has not provided the DNS IP address, contact your ISP to get that information or go to its website for the information. Click the OK button in the TCP/IP properties window, and click Close or the OK button for the Network window. Restart the computer when asked. Appendix A: Troubleshooting Common Problems and Solutions 38 Wireless-G Broadband Router with RangeBooster · For Windows 2000: 1. Click Start, Settings, and Control Panel. Double-click Network and Dial-Up Connections. Right-click the Local Area Connection that is associated with the Ethernet adapter you are using, and select the Properties option. In the Components checked are used by this connection box, highlight Internet Protocol (TCP/IP), and click the Properties button. [. . . ] This warranty does not apply if the Product (a) has been altered, except by Linksys, (b) has not been installed, operated, repaired, or maintained in accordance with instructions supplied by Linksys, or (c) has been subjected to abnormal physical or electrical stress, misuse, negligence, or accident. In addition, due to the continual development of new techniques for intruding upon and attacking networks, Linksys does not warrant that the Product will be free of vulnerability to intrusion or attack. TO THE EXTENT NOT PROHIBITED BY LAW, IN NO EVENT WILL LINKSYS BE LIABLE FOR ANY LOST DATA, REVENUE OR PROFIT, OR FOR SPECIAL, INDIRECT, CONSEQUENTIAL, INCIDENTAL OR PUNITIVE DAMAGES, REGARDLESS OF THE THEORY OF LIABILITY (INCLUDING NEGLIGENCE), ARISING OUT OF OR RELATED TO THE USE OF OR INABILITY TO USE THE PRODUCT (INCLUDING ANY SOFTWARE), EVEN IF LINKSYS HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. IN NO EVENT WILL LINKSYS' LIABILITY EXCEED THE AMOUNT PAID BY YOU FOR THE PRODUCT. [. . . ]