User manual LINKSYS WRT54GX2

[. . . ] ® A Division of Cisco Systems, Inc. 2. 4 GHz Wireless-G 802. 11g Broadband Router WIRELESS with SRX200 User Guide Model No. WRT54GX2 Wireless-G Broadband Router with SRX200 Copyright and Trademarks Specifications are subject to change without notice. Linksys is a registered trademark or trademark of Cisco Systems, Inc. Copyright © 2005 Cisco Systems, Inc. Other brands and product names are trademarks or registered trademarks of their respective holders. [. . . ] Click Start, Settings, and Control Panel. In The following network components are installed box, select the TCP/IP-> associated with your Ethernet adapter. If you only have one Ethernet adapter installed, you will only see one TCP/IP line with no association to an Ethernet adapter. Highlight it and click the Properties button. In the TCP/IP properties window, select the IP address tab, and select Specify an IP address. Enter a unique IP address that is not used by any other computer on the network connected to the Router. Make sure that each IP address is unique for each PC or network device. Click the Gateway tab, and in the New Gateway prompt, enter 192. 168. 1. 1, which is the default IP address of the Router. Click the Add button to accept the entry. Click the DNS tab, and make sure the DNS Enabled option is selected. Enter the Host and Domain names (e. g. , John for Host and home for Domain). Enter the DNS entry provided by your ISP. If your ISP has not provided the DNS IP address, contact your ISP to get that information or go to its website for the information. Click the OK button in the TCP/IP properties window, and click Close or the OK button for the Network window. Restart the computer when asked. Appendix A: Troubleshooting Common Problems and Solutions 41 Wireless-G Broadband Router with SRX200 · For Windows 2000: 1. Click Start, Settings, and Control Panel. Double-click Network and Dial-Up Connections. Right-click the Local Area Connection that is associated with the Ethernet adapter you are using, and select the Properties option. In the Components checked are used by this connection box, highlight Internet Protocol (TCP/IP), and click the Properties button. Select Use the following IP address option. Enter a unique IP address that is not used by any other computer on the network connected to the Router. Enter the Default Gateway, 192. 168. 1. 1 (Router's default IP address). [. . . ] INDUSTRY CANADA (CANADA) This device complies with Canadian ICES-003 and RSS210 rules. Cet appareil est conforme aux normes NMB-003 et RSS210 d'Industry Canada. The use of this device in a system operating either partially or completely outdoors may require the user to obtain a license for the system according to the Canadian regulations. EC DECLARATION OF CONFORMITY (EUROPE) Linksys declares that the Wireless-G Broadband Router conforms to the specifications listed below, following the provisions of the European R&TTE directive 1999/5/EC: EN 301 489-1, 301 489-17 General EMC requirements for Radio equipment. [. . . ]