User manual LINKSYS WRTP54G

[. . . ] ® A Division of Cisco Systems, Inc. 2. 4 GHz Wireless-G 802. 11g Voice Broadband Router with 2 Phone Ports User Guide Model No. WRTP54G Wireless-G Broadband Router with 2 Phone Ports Copyright and Trademarks Specifications are subject to change without notice. Linksys is a registered trademark or trademark of Cisco Systems, Inc. Copyright © 2005 Cisco Systems, Inc. Other brands and product names are trademarks or registered trademarks of their respective holders. [. . . ] Then power on the Router and other network devices. · Verify your account information and confirm that the phone line is registered with your Internet phone service provider. I'm trying to access the Router's Web-based Utility, but I do not see the login screen. Instead, I see a screen saying, "404 Forbidden. " If you are using Windows Explorer, perform the following steps until you see the Web-based Utility's login screen (Netscape Navigator will require similar steps): A. Make sure Work Offline is NOT checked. Appendix A: Troubleshooting Common Problems and Solutions 53 Wireless-G Broadband Router with 2 Phone Ports B. This is a hard refresh, which will force Windows Explorer to load new webpages, not cached ones. Make sure the security level is Medium or lower. I need to set a static IP address on a PC. The Router, by default, assigns an IP address range of 192. 168. 15. 100 to 192. 168. 15. 150 using the DHCP server on the Router. To set a static IP address, you can only use the ranges 192. 168. 15. 2 to 192. 168. 15. 99 and 192. 168. 15. 151 to 192. 168. 15. 254. Each PC or network device that uses TCP/IP must have a unique address to identify itself in a network. If the IP address is not unique to a network, Windows will generate an IP conflict error message. You can assign a static IP address to a PC by performing the following steps: For Windows 98 and Millennium: A. Click Start, Setting, and Control Panel. In The following network components are installed box, select the TCP/IP-> associated with your Ethernet adapter. If you only have one Ethernet adapter installed, you will only see one TCP/IP line with no association to an Ethernet adapter. Highlight it and click the Properties button. In the TCP/IP properties window, select the IP address tab, and select Specify an IP address. Enter a unique IP address that is not used by any other computer on the network connected to the Router. You can only use an IP address in the ranges 192. 168. 15. 2 to 192. 168. 15. 99 and 192. 168. 15. 151 to 192. 168. 15. 254. Make sure that each IP address is unique for each PC or network device. Click the Gateway tab, and in the New Gateway prompt, enter 192. 168. 15. 1, which is the default IP address of the Router. [. . . ] If this equipment causes harm to the telephone network, the telephone company may discontinue your service temporarily. If advance notice is not practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary. The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the operation of the equipment. [. . . ]