User manual LINKSYS WRTSL54GS

[. . . ] Connect the AC power adapter to the Router's Power port and the other end into an electrical outlet. Make sure the Power and Internet LEDs on the front panel light up green. The Power LED will flash green for a few seconds when the Router goes through its selfdiagnostic test. This LED will stay solidly lit when the self-test is complete. [. . . ] Power on the PC you wish to use to configure the Router. Proceed to Step 2. These instructions will show you how to configure the Router. You only need to configure it once. NOTE: Make sure your PC's Ethernet adapter is set to obtain an IP address automatically. For more information, refer to Windows Help. E A B G IMPORTANT: Make sure you use 1 A Connect the Broadband Router Before you begin, make sure that you have the setup information for your specific type of Internet connection. The installation technician from your ISP should have left this information with you after installing your broadband connection. If not, you can call your ISP to request the settings. Make sure that all of your network's hardware is powered off, including the Router, PCs, and cable or DSL modem. Connect one end of an Ethernet network cable to one of the ports (labeled 1-4) on the back of the Router, and the other end to an Ethernet port on a PC. F G H I Open your web browser. Enter http://192. 168. 1. 1 in its Address field. Leave the User Name field empty, and enter the default password, admin, in lowercase letters in the Password field. Change these settings as described here and click the Save Settings button to apply your changes. NOTE: For more advanced settings and security options, refer to the User Guide on the Setup CD-ROM. L M N Power your cable or DSL modem off and back on again. Test the setup by opening your web browser and entering http://www. linksys. com/registration. E Internet Configuration Type Automatic Configuration - DHCP: If you are connecting through DHCP or a dynamic IP address from your ISP keep this default setting. , Static IP: If your ISP assigns you a static IP address, select Static IP from the drop-down menu. Complete the Internet IP Address, Subnet Mask, Gateway, and DNS fields. You need to enter at least one DNS address. PPPoE: If you are connecting through PPPoE, select PPPoE from the drop-down menu. Complete the User Name and Password fields. PPTP: PPTP is a service used in Europe only. If you are using a PPTP connection, check with your ISP for setup information. DHCP When you have finished entering your Internet connection settings, click the Save Settings button to save your changes. To configure the Router for your wireless network, select the Wireless Tab's Basic Wireless Settings screen. [. . . ] To configure the Router for your wireless network, select the Wireless Tab's Basic Wireless Settings screen. Select the Wireless Network Mode: Mixed: If your network has Wireless-G and Wireless-B devices, then keep the default setting, Mixed. G-Only: If your network only has Wireless-G devices, select G-Only. B-Only: If your network only has Wireless-B devices, select B-Only. [. . . ]