User manual LITTERMAID LM680

[. . . ] PLEASE READ AND SAVE THIS USE AND CARE BOOK. ® FOR SINGLE-CAT HOUSEHOLDS Lucy USA/Canada www. littermaid. com 1-800-LITMAID (548-6243) Model LM680 Accessories/Parts (USA/Canada) 1-800-738-0245 IMPORTANT SAFEGUARDS NOT INTENDED FOR USE WITH KITTENS UNDER SIX MONTHS. Not intended for use by handicapped, incapacitated or older cats that might experience difficulty in entering or leaving the litter box. PREGNANT WOMEN and IMMUNE-DEFICIENT PEOPLE should avoid contact with cat waste at all times. The LitterMaid® Self-Cleaning litter box is a precision-operated appliance. [. . . ] Remove excess litter and smooth out litter from front to back using the LitterMaid® tool. Turn On/Off button to "on. " 5. Rake will run through a complete cleaning cycle. When cycle is finished, unit is ready for use. · There is an obstacle in front of the rake (most often a clump of litter stuck to bottom of the litter tray or too much litter in tray. ) If rake cannot move an obstacle during cleaning cycle, unit will go through a cleaning cycle up to five times in an attempt to clear obstacle. If unsuccessful, rake will return to its home position, and red light will blink slowly (approximately every second), indicating that the rake has encountered an obstacle it cannot move. Turn On/Off button to "off. " 2. Check to make sure litter in tray is just below the "Max Line. " Use the LitterMaid® scoop and rake cleaner to measure level of litter in the center of unit. Full line will not be visible if tray is overfilled. Remove excess litter and smooth out litter from front to back using the LitterMaid® scoop and rake cleaner. . Turn On/Off button to "on. " 6. Rake will run through a complete cleaning cycle. When cycle is finished, unit is ready for use. Unit does not operate 10 minutes after cat leaves. (Sensors need to be covered for 5 seconds to activate. ) 1. Wipe each sensor with a soft, dry cloth to remove dust. Turn On/Off button to "off. " 3. Turn On/Off button to "on. " 4. Unit will run through a cleaning cycle. C. Unit does not completely clean litter box. Probable Cause: · Low-quality clumping litter. Do not use non-clumping, crystal or pearl-like litter. [. . . ] Note: Do not use scouring pads or harsh and abrasive chemicals. Reinstalling rake: · Hold rake with both hands and align the two indentations on the rake with the two buttons on the motor housing (Fig. 14). CAUTION: MOTOR STARTS AUTOMATICALLY WITHOUT WARNING. KEEP HANDS, CLOTHING AND CHILDREN CLEAR OF UNIT. [. . . ]