User manual LITTERMAID SELF-CLEANING LITTER BOX

[. . . ] SAVE THIS MANUAL Self-Cleaning Litter Box INSTALLATION AND OPERATION MANUAL IMPORTANT INFORMATION INSIDE! Please read prior to product installation and operation. WELCOME TO THE LITTERMAID BRAND FAMILY! QUICK SETUP INSTRUCTIONS s s s s s s s s s Fill only with premium clumping litter just below the full line. Do not overfill or unit will not operate properly. Do not use crystal or pearl-like types of litter. Unpack power supply and cord from carton. [. . . ] Light blinks quickly Probable Cause: s Batteries need replacing. Probable Cause: s No AC power is reaching unit or batteries are dead. More help and information are available by calling Applica Customer Service at 1-800-LIT-MAID (548-6243). 3 4 INSTRUCTIONS FOR USE PRODUCT MAY VARY SLIGHTLY FROM ILLUSTRATIONS Safety Bar (not shown) Rake Sensors Restraints INSTALLATION OF WASTE RECEPTACLE 1. Insert waste receptacle into disposal area of the unit. Be sure the two notched corners on the bottom of the waste receptacle rest on the horizontal posts of the unit. Slip the edge of the waste receptacle 5 TABS UNDERNEATH the ridged tabs of the unit, making sure it snaps in place securely. Lift the waste compartment cover and position the waste receptacle lid with its two round "fasteners" FIG. Insert the two raised areas into the two round openings in the waste receptacle compartment cover. PUSH each raised area of the lid into its corresponding opening. The raised areas on waste receptacle lid should extend through the waste compartment cover by approximately 1/2 inch. REMOVING WASTE RECEPTACLE See instructions under CARE AND CLEANING. INSTALLING (OPTIONAL) PAW CLEANING RAMP The paw cleaning ramp has two pivot pins. The unit has two holes located on the sides of the waste receptacle end of the unit. Position the paw cleaning ramp with fabric side facing up. Point the pivot pins toward the waste receptacle end of the unit. Lift the paw cleaning ramp and insert one of the pivot pins into one of the holes. Slightly stretch the other pivot pin to reach the other hole, then insert (Fig. Tug slightly on paw cleaning ramp to assure ramp is secure. Battery Compartment (batteries not included) Red Power Indicator Light AC Adapter Power Jack On/Off Switch Side Panels Latch Cleaning Brush Litter Tray Waste Receptacle Compartment Cover FIG. 3 UNPACKING: s Remove unit from carton. s Remove all tape wrapped around battery compartment and waste receptacle compartment. s Remove the unit including insert that protects the rake during shipping. s Using scissors or wire cutters, carefully remove restraints around rake assembly. [. . . ] Note: Use the cleaning brush to clean the rake quickly and easily. Align the 4 slots on the rake with the screws on the rake assembly housing and push to snap in place. Press firmly at the base of the rake, so that it clicks onto the rake assembly housing, indicating the rake has been properly installed. There should be no space between the edge of the rake and the rake assembly housing. [. . . ]