User manual LORUS Y704

[. . . ] · T i m e i n d i c a t i o n : Changeover between 12- and 24-hour indications is possible. D a i l y a l a r m : The alarm can be set to ring on a 24-hour basis. D u a l t i m e : Time of a different time zone can be set and displayed. S t r o k e f u n c t i o n : The watch can be set to beep at a selected rate to serve as a pacemaker in jogging, etc. [. . . ] W h e n s e t t i n g t h e h o u r d i g i t s i n t h e 1 2 hour indication, check that AM/PM is properly set. Only "PM" is displayed and there is no indication for the AM setting. In the 24hour indication, there is no indication. Engagement/disengagement of the alarm · With each depression of button "D" in the alarm display, the alarm is engaged and disengaged alternately. Alarm engaged s HOW TO SET THE TIME/CALENDAR Month (Day) B C Date D PM mark Hour M inutes A Seco nds Alarm disengaged · The alarm rings at the designated time for 18 seconds and stops. To stop it manually, depress button "A", "B", "C" or "D". * With each depression of button "B", month and day are displayed alternately. * With each depression of button "D", the display changes over between the 12- and 24-hour indications. Depress button "A" to show the time/calendar d i s pl a y . Depress button "C" to show the time/calendar setting display. Selection of the digits to be adjusted (flashing) is made in the following order by depressing button "D". Minutes Minutes Seconds Hour(tens digit) (units digit) Day D a t e M o nth 4. D e p r e s s b u t t o n " B " t o s e t t h e f l a s h i n g digits. One digit is advanced with each depression of button "B". Digits except seconds move quickly by keeping button "B" depressed. After all the adjustments are completed, depress button "A" to return to the time/ calendar display. Seconds setting When the seconds digits are flashing, depress button "B" in accordance with a time signal. The seconds are reset to "00" and start immediately. Note: When setting the hour digits in the 12-hour indication, check that AM/ PM is properly set. Only "PM" is displayed and there is no indication for the AM setting. In the 24-hour indication, there is no indication. s HOW TO SET THE DUAL TIME Time of a different time zone can be set and displayed together with the time you have set in "HOW TO SET THE TIME/CALENDAR". Dual time display mark B C D PM mark Hour Min u tes A Seconds 1. Depress button "A" to show the dual time d isplay. [. . . ] · Do not operate the buttons when the watch is wet. · If the watch is exposed to salt water, rinse it in fresh water and then wipe it thoroughly dry. Caution: Leather straps are not water resistant except so indicated, even if the watch head is water resistant. · ALLERGIC REACTION Because the case and band touch the skin directly, it is important to clean them regularly. [. . . ]