User manual LOWRANCE EP-60R FUEL FLOW QUICK GUIDE

[. . . ] 988-0154-432 EP-60R Fuel Flow Electronic Sensor Installation, Configuration and Calibration Instructions This document shows how to install an EP-60R Fuel Flow sensor and how to connect it to a NMEA 2000® network. It also provides instructions on how to configure and calibrate your fuel flow sensor with Lowrance digital gauges (LMF-200 & LMF-400) and display units. NMEA 2000 is the communication bus standard developed by the National Marine Electronics Association (NMEA) for use in boats. Lowrance has introduced a line of products that can communicate over a NMEA 2000 network (LowranceNet). [. . . ] Select the desired data location and press ENTER. If your unit is configured for more than one tank the Select Tank menu will appear. NOTE: If your unit is configured for a single-tank, the Select Tank menu will not appear. Press EXIT repeatedly to return to the main display where Fuel Used data will be displayed on the Fuel Manager page. Highlight the desired tank option and press ENTER. Press EXIT twice to return to the main display where Fuel Used data will be displayed on the Fuel Manager page. To check fuel flow accuracy: 1. Make sure the Fuel Remaining Source has been set to Fuel Flow then fill up the tank connected to the fuel flow you want to calibrate. Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press ENTER. If your unit is configured for more than one tank, the Select Tank menu will open. Select the tank you refilled and press ENTER. A Recalibration window (ReCalibrate?) will appear with two options: Yes and No. The following message will appear: Press Enter after refilling the fuel tank. Take your boat out, but run only ONE engine -- the engine connected to the fuel flow. Burn at least 5 gallons of fuel, then fill up the tank again, noting how much fuel was added to the tank. Check the Fuel Manager page for the fuel used figure calculated by the LMF-400. Compare the amount of fuel added when you filled up the tank with the LMF-400 Fuel Used figure. If the difference between these two numbers is greater than 3 percent, you need to calibrate the unit. To calibrate a fuel flow: 8. Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press ENTER. 9. If your unit is configured for more than one tank, the Select Tank menu will open. Select the tank you refilled and press ENTER. The Recalibration menu will appear with two options: Yes and No. The Filled Fuel Quantity window will appear. [. . . ] Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty does NOT apply in the following circumstances: (1) when the product has been serviced or repaired by anyone other than us; (2) when the product has been connected, installed, combined, altered, adjusted, or handled in a manner other than according to the instructions furnished with the product; (3) when any serial number has been effaced, altered, or removed; or (4) when any defect, problem, loss, or damage has resulted from any accident, misuse, negligence, or carelessness, or from any failure to provide reasonable and necessary maintenance in accordance with the instructions of the owner's manual for the product. We reserve the right to make changes or improvements in our products from time to time without incurring the obligation to install such improvements or changes on equipment or items previously manufactured. This warranty gives you specific legal rights and you may also have other rights which may vary from state to state. [. . . ]