User manual LOWRANCE EP-65R FLUID LEVEL QUICK GUIDE

[. . . ] 988-0154-372 EP-65R Fluid Level Electronic Sensor Installation, Configuration and Calibration Instructions This document shows how to install an EP-65R Fluid Level sensor and how to connect it to a NMEA 2000® network. It also provides instructions on how to configure and calibrate your fluid level sensor with Lowrance digital gauges (LMF-200 & LMF-400) and display units. NMEA 2000 is the communication bus standard developed by the National Marine Electronics Association (NMEA) for use in boats. Lowrance has introduced the LowranceNetTM, a line of products that can communicate over a NMEA 2000 network. [. . . ] You will fill the tank to complete calibration. 29 NOTE: Adequate calibration may be achieved without calibrating both points and you can calibrate the points (Empty Level and Full Level) in any order you wish. In the following instructions, we begin calibration with an empty tank. To execute 2-Point calibration: 1. Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press ENTER. Choose the fluid level you want to calibrate and press ENTER. The Number of Points menu will appear with three options: 2, 3 and 5. Select 2, for two-point calibration, and press ENTER. The Levels menu will appear with two choices: Empty Level and Full Level. The following message will appear: Set Tank to Empty Level Press Enter. Make sure your tank is empty and then press ENTER. You will be taken back to the Levels menu. The following message will appear: Set Tank to Full Level Press Enter. Press EXIT repeatedly to return to the main display. 3-Point Calibration 3-point calibration is designed for tanks that vary in shape from the top to the bottom. You can begin calibration at any point in the 3-point process, but we recommend starting calibration with an empty tank. In a 3-point calibration, you will set three points, one each for empty, half and full levels. NOTE: Adequate calibration may be achieved without calibrating all three points, and you can calibrate the points (Empty Level, Half Level and Full Level) in any order you wish. We begin calibration with an empty tank. To execute 3-Point calibration: 1. Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press ENTER. Choose the fluid level you want to calibrate and press ENTER. The Number of Points menu will appear with three options: 2, 3 and 5. Select 3, for three-point calibration, and press ENTER. [. . . ] Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty does NOT apply in the following circumstances: (1) when the product has been serviced or repaired by anyone other than us; (2) when the product has been connected, installed, combined, altered, adjusted, or handled in a manner other than according to the instructions furnished with the product; (3) when any serial number has been effaced, altered, or removed; or (4) when any defect, problem, loss, or damage has resulted from any accident, misuse, negligence, or carelessness, or from any failure to provide reasonable and necessary maintenance in accordance with the instructions of the owner's manual for the product. We reserve the right to make changes or improvements in our products from time to time without incurring the obligation to install such improvements or changes on equipment or items previously manufactured. This warranty gives you specific legal rights and you may also have other rights which may vary from state to state. [. . . ]