User manual LOWRANCE EP-80R TEMP SENSOR QUICK GUIDE

[. . . ] 988-0154-472 Installation and Configuration Instructions This document shows how to install an EP-80R temp sensor and how to connect it to a NMEA 2000® network. It also provides instructions on how to configure your temp sensor with Lowrance digital gauges (LMF200 & LMF-400) and display units. NMEA 2000 is the communication bus standard developed by the National Marine Electronics Association (NMEA) for use in boats. Lowrance has introduced a line of products that can communicate over a NMEA 2000 network (LowranceNet). [. . . ] The first set of instructions below will show you how to switch the configuration of a water temp to an outside temp. If all temps configured (Configuration name unavailable): 1. Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press ENTER. 2. Select OUTSIDE TEMP and press ENTER to open the temp configuration menu. The following message will appear: Press Enter to UnConfig Device Name. You will be directed to the Bus Devices list. The Outside temp is unconfigured and will be displayed as UnCfg Temp. Its configuration name (Outside) is now available, so it can be used to reconfigure the Water temp sensor. Highlight WATER TEMP and press ENTER, which will open the temp configuration menu. That will direct you to the Temp Selection menu, which will have three options: Water, Outside and Inside. You will be taken back to the Bus Devices list. The temp you just reconfigured (formerly water temp) will now be displayed as Outside Temp. To configure the unconfigured Temp (formerly Outside temp), highlight UNCFG TEMP from the Bus Devices list and press ENTER to open the Temp Selection menu, which will have three options: Water, Outside and Inside. You will be taken back to the Bus Devices list. If desired configuration name available: 1. Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press ENTER. 2. Select WATER TEMP and press ENTER to open the configuration options menu. Select RECONFIGURE and press ENTER to open the Temp Selection menu, which will have three options: Water, Outside and Inside. You will be directed to the Bus Devices list where the temp will now be shown as Outside Temp. NOTE: If your temp sensor is not updated on the Bus Devices list, refresh the list by closing it and then access it again. Displaying EP-80R Temp Sensor data: You can display temp sensor data on the Single Analog, Dual Analog, Quad Analog, Single Digital, Dual Digital and Quad Digital pages. Page Screen Rotation The Page Screen Rotation consists of multiple pages that have been set up for display. Once pages have been added to the page screen rotation, they can be set to scroll across the screen automatically or manually. Use the ENTER and EXIT keys to manually scroll pages across the screen. Pressing the ENTER key moves the scroll in one direction. [. . . ] Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty does NOT apply in the following circumstances: (1) when the product has been serviced or repaired by anyone other than us; (2) when the product has been connected, installed, combined, altered, adjusted, or handled in a manner other than according to the instructions furnished with the product; (3) when any serial number has been effaced, altered, or removed; or (4) when any defect, problem, loss, or damage has resulted from any accident, misuse, negligence, or carelessness, or from any failure to provide reasonable and necessary maintenance in accordance with the instructions of the owner's manual for the product. We reserve the right to make changes or improvements in our products from time to time without incurring the obligation to install such improvements or changes on equipment or items previously manufactured. This warranty gives you specific legal rights and you may also have other rights which may vary from state to state. [. . . ]