User manual LUMAGEN VISION PRO BROCHURE

[. . . ] Vision Pro Video Processor User Ma nual and Installer Guide LEGAL NOTICES: BEFORE USING THIS PRODUCT YOU MUST ACCEPT THE TERMS OF THE LICENSE AGREEMENT. IF YOU DO NOT AGREE TO BE BOUND THE TERMS OF THE LICENSE AGREEMENT, RETURN THE PRODUCT TO THE POINT OF SALE IMMEDIATELY. BY DISASSEMBLING OR USING THE PRODUCT, YOU ACCEPT ALL TERMS OF THE LICENSE AGREEMENT. TO THE EXTENT NOT PROHIBITED BY LAW, IN NO EVENT SHALL LUMAGEN, ITS SUPPLIERS, OR ITS DEALERS, BE HELD LIABLE FOR INJURY TO PERSONS OR PROPERTY, ANY LOST REVENUE, LOST PROFIT, SPECIAL, INCIDENTAL, INDIRECT, CONSEQUENCIAL, OR PUNITIVE DAMAGES, IMPAIRMENT OF OR DAMAGE TO OTHER GOODS, HOWEVER CAUSED REGARDLESS OF THE THEORY OF LIABILITY, RESULTING FROM THE USE OF, OR INABILITY TO USE, THIS PRODUCT, EVEN IF LUMAGEN, ITS SUPPLIERS, OR ITS DEALERS, HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. [. . . ] · For parenthesized lists, select one button from the list. · For square-bracketed lists, press as needed. Example: For the list [ , , , ], press the arrow keys as needed. · For menu commands press the MENU button. The , and arrow keys are used to select the function. The arrow key is used to enter sub-menus. This is shown as: MENU MenuItem MenuItem. · Numerical entries are listed as value. While entering the value, the arrow key acts as a backspace key. · Some commands are activated immediately. Other commands must be explicitly accepted by pressing OK. If needed, OK is listed as part of the command. · Pressing EXIT cancels a partially completed command. If the menu system is active, EXIT returns to one level higher in the menu system. · There are two independent configuration memory types for each input (MEMA, and MEMB). The input setup and output resolution/timing can be set independently for each memory. Note that, initially, there is a single output mode for all configuration memories. To program an input memory, first select the input, then press the appropriate configuration memory button, and use the menu system to configure. · Some menu commands are only available when their respective input is selected. Example: Calibration commands, such as contrast, are not available when the passthrough input is selected. · Before changes are saved, they can be discarded by entering standby mode. · Save the configuration after making changes, or they will be lost when entering STBY mode. [. . . ] The pass-through inputs are actively buffered, have a nominal bandwidth of 300 MHz and a ±1. 1 volt nominal input/output range. All video inputs use BNC female jacks and are terminated into 75 ohms. Absolute maximum rating is ±2 volts for video inputs. For other inputs it is +3. 3, ­0 volts, except for the RS232 port which is ±12 volts. Processing Per-pixel motion adaptive deinterlacing with 3:2 and 2:2 pulldown frame reconstruction. [. . . ]