User manual LUX RO300 100V

[. . . ] 822 90 16-XX 16-33 Your new water purifier EN THANK YOU for entrusting us to supply your new water purifier. We are confident it will provide you with many years of trouble-free use. To avoid problems, it is important for you to read the user instructions. Read the «Safety information» and the «Installation» instructions especially carefully. [. . . ] Remove the filter and discard it (should not be saved). Fill the container with 7 dl of lukewarm water and pour in 1/4 dl of disinfectant. Start the water purifier and produce pure water for 30 seconds. While production is in progress, pull out the plug as shown in fig. Allow the water purifier to stand for around 30 minutes. Disconnect the container and insert a new filter into it, in accordance with «Replacing the filter», points 7 - 8. Flush the water purifier in accordance with «Flushing». Do not use the purified water until flushing is complete. The disinfection process is now finished. The water purifier is ready to be used. - 10 - Maintenance Storage The water purifier should be put into storage if: q E it is going to be disconnected from water and electricity for an extended period (1 week or more). it is not going to be used to produce purified water for a period of 4 months or longer. q Preserving agents can be ordered from your dealer, see «Consumables». The preserving agent must be kept out of reach of children!Check that the water purifier is in standby mode. Close the shut-off valve on the feed water connection. Disconnect the feed water hose from the shut-off valve. Unscrew the filter container in accordance with «Replacing the filter», points 2 - 5. Remove the filter and discard it (should not be saved). Put the filter container back in accordance with «Replacing the filter», points 8 - 9. Mix 2 litres of preserving agent and 2 litres of water in a bucket. Insert the feed water hose in the mixture, making sure that the mouth of the hose is constantly below the surface level of the liquid, see fig. The water purifier now draws the mixture into it. Stop the production of pure water once all the liquid has been fed into the water purifier. [. . . ] Check that the seal is in place in the connection. Open the shut-off valve on the feed water and check that there is no leakage at the feed water hose. 2. Pure water The pure water is routed via the pure water hose to the faucet installed on the sink unit. Connect the pure water hose from the pure water faucet to the water purifier. Push the hose into the bottom position, up to the mark (approx. [. . . ]