User manual LUXMAN SQ507X

[. . . ] Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. To ensure good ventilation, the back panel of the cabinet must be removed. It is advisable to install the oven so that it rests on two strips of wood, or on a completely flat surface with an opening of at least 45 x 560 mm (see diagrams). [. . . ] bARBECUE mode The top heating element comes on. The high and direct temperature of the grill is recommended for food that requires high surface temperature. Always cook in this mode with the oven door closed. GRATIN mode The top heating element, as well as the fan, will come on. This combination of features increases the effectiveness of the unidirectional thermal radiation of the heating elements through forced circulation of the air throughout the oven. This helps prevent food from burning on the surface, allowing the heat to penetrate right into the food. Always cook in this mode with the oven door closed. PIZZA mode The bottom and circular heating elements, as well as the fan, will come on. This combination heats the oven rapidly by producing a considerable amount of heat, particularly from the bottom element. If you use more than one rack simultaneously, switch the position of the dishes halfway through the cooking process. BAKING mode The rear heating element and the fan come on, guaranteeing the distribution of heat delicately and uniformly throughout the oven. To restore the minimum power level, turn the knob and set it back to position 0. For double cooking zones, the first part of the knob movement activates the smaller cooking zone (internal). Once cooking is completed, the timer will ring; to turn it off, simply press any button except the ) and * buttons. Immediate start for a specified period By programming just the duration (points 1 and 2 of the “Delayed cooking time for specified period” section), cooking will begin immediately. To cancel a cooking schedule already programmed Press the $ button, and use the ) button to set the time to: Button Functions: H : Timer with hours and minutes; $ : cooking time; % : end cooking time; ( : Manual change; ) : set cooking time (to count down); * : set cooking time (to start from zero) How to reset the digital clock After the appliance has been connected to the power supply, or after a power cut, the clock display will automatically reset to 0:00 and begin to blink. • Press the $ and % buttons consecutively and then reset the time (within 4 seconds) using the ) and * buttons. The time can also be changed in the following two ways: 1. Press the ( button, and then use the ) and * buttons to reset the time. Manual operation of the oven Once the time has been set, the programmer automatically switches to manual mode. Note: Press the ( button to restore the manual mode after every “Automatic” cooking session. Delayed cooking time for a specified period The total cooking time as well as the time at which the cooking will finish must be set. [. . . ] • Always make sure the knobs are in the “l”/“¡” position when the appliance is not in use. • When unplugging the appliance always pull the plug from the mains socket, do not pull on the cable. Disposal • Observe local environmental standards when disposing packaging material for recycling purposes. Observe existing legislation when disposing of the old appliance. [. . . ]