User manual LYNX 4TS630A

[. . . ] General safety guidelines and warnings Removal and disposal of packaging Environmental protection / Saving energy Installing the appliance Removing the transport security devices Fixing the appliance Connecting to the water supply Water drainage Connecting to the electricity supply Getting to know your new appliance Programme selector Function selection and start buttons 3 3 4 4 4 5 5 6 6 7 8 8 Detergents and additives First washing cycle Preparing the laundry for washing Loading the laundry Washing the laundry End of the wash programme/Removing the laundry Cleaning / Maintenance / Frost protection Minor faults with simple solutions Technical data Technical Assistance Service Consumption figures 12 14 14 15 15 p. 8 9 9 10 10 11 1 2 3 4 5 6 7 2 en 8 9 General safety guidelines and warnings This appliance complies with current safety standards in the sector. Points to bear in mind when washing clothes: !The appliance should only be used with cold water from the public water supply. The appliance should only be used for washing clothes suited to household washing machines. [. . . ] rápido: the washing cycle is shorter. menos plancha: laundry comes loose in the prelavado: a prewash cycle is carried out. inicio M: The selected programme is activated. The «preparado-activo» indicator comes on. For security reasons, the machine does not start until the door is closed properly. drum to avoid creasing. Detergents and additives All standard use detergents for automatic washing machines can be used. Do not use detergents with solvents in the washing machine!Do not use additives, cleaning sprays or stain removers in the vicinity of the appliance, as they may damage it. Keep detergents and additives in a safe place, away from children. Amount of detergent Only using the correct measure of detergent will guarantee good wash results. Note the manufacturer's recommendations. 8 en First washing cycle Carry out the first washing cycle without any laundry in the machine to remove residual wa ter left inside the drum as a result of testing of the machine at the factory. m Pour approximately 2 litres of water and half a measuring glass of normal detergent into the compartment II of the detergent drawer. m Set the programme selector to «algodón 90ºC». The «preparado-activo» indicator light flashes. m Press the «inicio M» button. The «prepara do-activo» indicator comes on. Before adding the laundry to the washing machine, make sure there are no foreign bodies or animals enclosed in the drum. m Add the outspread and unfolded laundry, mixing large and small items. Pour detergent m Pour detergent without exceeding the maxi mum filling level mark. - Compartment I: Detergent for pre-washing. - Compartment II: Detergent for main wash, li mescale remover, stain removing salt. . . - Compartment 2 : Additives for the last rinse, for example softeners. m Turn on the tap. Washing the laundry Starting a programme m Turn the programme selector to the required wash programme. The «preparado-activo» indicator light flashes. m Press one or more function selection buttons (optional). The relevant status indicator light comes on. [. . . ] The electronic control reduces con sumption mantaining all the features. Measu re out the detergent in line with the manufacturer's instructions. Select the most suitable wash programme for the laundry. Disconnect the appliance for 5 10 minutes. [. . . ]