User manual LYNX 4VF340ND

[. . . ] 9000 133 959 (8511) en Index 4 6 7 8 9 10 11 14 Programme overview . 17 18 19 21 24 24 25 26 Safety instructions . . en Safety instructions Delivery Immediately check the packaging and dishwasher for any damage which may have been caused in transit. Do not use a damaged appliance, but consult your supplier. [. . . ] when they have cooled down. Switching the dishwasher ON Turn on the tap. Indicators light up according to the last programme that was selected. This same programme will run again if no other programme button 8 is pressed For appliances with top basket feature: If only the top basket is loaded, press the top-basket button 3 . The programme starts automatically. 18 en Programme interruption Carefully open the door, it could happen that water splashes out of the appliance. Only open completely when the spray arm no longer turns. If the programme is already in "drying" mode, an acoustic signal reminds you to close the appliance door or to abort the programme. If warm water is connected or if the machine is already heated up and the appliance door has been opened, leave the door slightly ajar, then close it, otherwise the appliance door can jump open through the expansion. In order to continue the programme flow, switch the main switch ON again and close the door. Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. Therefore you should occasionally have a careful look inside your dishwasher. Overall condition of the machine Check spray arm for grease and limescale deposits. If you find such deposits: Fill the detergent dispenser with detergent, start the appliance without utensils in the programme which has the highest wash temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. Regularly wipe the door seal with a damp cloth to remove deposits. Never use a steam cleaner to clean your dishwasher. The manufacturer is not liable for any consequential damage. Regularly wipe the front of the appliance and panel with a damp cloth; water and a little washing-up liquid will suffice. Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. Never use other chlorinated household detergents!Health hazard! Cancel programme (Reset) Only when the master switch is ON. Press the A and C programme buttons simultaneously and hold them pressed for approx. The PROGRAMME END indicator and the indicator for the programme that has just been terminated light up. To restart the dishwasher, set main switch 1 to ON again and select desired programme. Special dishwasher salt Check the LOW SALT indicator Top up with salt, if required. 5 Changing the programme It is possible to change the programme selection after you have switched the dishwasher on, provided that you have not yet closed the door. If it is necessary to change the programme after this, the programme cycle that has already begun (e. g. [. . . ] Turn off the tap. Protection from freezing temperatures If the appliance is installed in a location where there is a risk of freezing temperatures (e. g. in a holiday home), all water must be completely drained out of the interior (see "Transporting the dishwasher"). Turn OFF the tap, disconnect the supply hose and allow to drain. 26 en Disposal of the packaging Please dispose of the packaging material in an environmentally friendly manner. Keep children away from shipping carton and packaging components. [. . . ]