User manual M-AUDIO EVOLUTION UC16

[. . . ] Alternatively, you can press the CONTROL SELECT button and then type in the number using the keypad or `+', `-` buttons. Press the CONTROL ASSIGN button and enter the new number using the keypad. To change one of the assignable controllers, the UC16 uses the following method: Press the CONTROL SELECT button and release. Alternatively simply move the rotary control. [. . . ] The new value is sent out except for the CONTROL ASSIGN which sends data when the display stops flashing) When the display stops flashing the keyboard returns to normal operation. Numeric Keys Initially the LED display starts flashing. A numeric value can be typed in using the numbers 0-9. As each key is pressed the display continues to flash, the time-out value is reset. When a complete number* has been entered the display stops flashing and the value is selected. Alternatively, if no key is pressed and the display stops flashing the number on the display is selected. The update routine is triggered, so that the new value is sent out. When the display stops flashing the keyboard returns to normal operation. * The following table shows how many keys are required to enter a complete number:Channel Memory Control Select Control Assign 1 key 2-9 0-9 2-9 2 keys 01, 10-16 01, 10-14 14-99 000-013, 100-132 3 keys 5. Snap Shot When both SNAP SHOT keys are pressed the UC-16 sends out the settings for all of the Assignable Controllers. The settings will be sent out on whichever channel each rotary dial is assigned to (see channel assignment later). This feature lets you record the settings of the Knobs into your sequencer. It is handy for setting up parameters in a song. Set the UC16 to all parameter levels you desire, engage record mode on your sequencer and press the SNAP SHOT buttons. 6. Memory banks and Presets There are 25 memory banks in total. Memory banks 1-4 are accessible using the Preset buttons 1-4 respectively. This allows you to store settings you use a lot and makes for easy access to them. The rest of the memory banks are accessible by pressing the RECALL button, then using either the +/- buttons or the numeric keys to type in the number of the memory bank you want (1-25). By default the remaining presets are: 5. Waldorf PPG wave 2V 10. Propellerhead's Rebirth Master 11. Propellerhead's Rebirth Rhythm section 12. Reason Subtractor 13. Reason Dr. Rex 14. Reason NN-19 15. AAS Lounge Lizard 16. Native Instruments Traktor DJ 17. cc numbers 40 ­ 55. 18. cc numbers 75 ­ 90 19. cc numbers 102 ­ 117 20. Volume (cc7) on channels 1 ­ 16 21. Pan (cc7) on channels 1 ­ 16 Bank numbers 22 ­ 25 have the same default as bank number 4. For a fully detailed list of the memory bank presets please look at the UC16 Memory bank definitions document bundled with your UC16, or available to download from our website. [. . . ] When `NO' is selected the MIDI Out sends the data from the UC16. When YES is selected the MIDI Out sends the MIDI data received from USB. The status of MIDI OUT FROM USB will be saved in non-volatile memory and restored when the UC16 is switched on again. The factory default is set to NO. 9. SPECIFICATIONS 1. [. . . ]