User manual M-AUDIO OZONE F

[. . . ] IMPORTANT: The Ozonic comes with a high quality six-pin to six-pin FireWire cable. We strongly suggest that you use this cable, or one of equal quality, for optimum audio performance. Your computer is equipped with either a six-pin or a four-pin interface, while the connector on the Ozonic is six-pin. The Ozonic requires a powered six-pin FireWire connection in order to receive bus power; if your computer has a four-pin connection or a 6-pin connection that does not provide power, you will need to use the supplied power adapter with an adapter cable. [. . . ] Use this feature if you are switching between presets with the controllers out of position. You will be able to move the controller to a position relative to the software's controller value, rather than causing the software's controller value to jump. < Null Mode Null mode allows you to switch from preset memory to preset memory without losing the last value the MIDI controller was sending. Each time you recall a different memory, the values of all your controllers are remembered by the Ozonic before the new memory is recalled. If Null mode is enabled and you go back to a previous memory, the controllers will all be muted until the last used value that was sent by that controller has been reached. This means that if a controller is altered from the remembered Null value for the recalled preset, no MIDI data will be sent out until the Null value of a controller is reached. If you turn a controller that is altered from its Null value, the LCD will display the Offset value for the controller. The Offset value is the numeric distance the controller is from its Null value. If the Offset is a negative value, the Null value is above the controller's current position. If the Offset is positive, the Null value will be below the controller's current position. The Offset value will increase or decrease towards 0 as you move the controller nearer to its Null value. Of course, you can also change the cut-off and resonance messages to whatever you like. It is necessary to use the Control Select key to select the four joystick controllers for edit. The various joystick controllers are: Left to Right Right to Left Bottom to Top Top to Bottom B18 B19 B20 B21 < The Aftertouch Strip The Aftertouch strip is made of pressure-sensitive material that lies beneath the keys on your Ozonic keyboard. Aftertouch is useful for replicating acoustic instrument sounds. Try varying the pressure while playing Ozonic's keys. The Aftertouch strip is an assignable controller, just like the rotary dials and faders on your Ozonic. Therefore, you can assign it to any of the MIDI messages outlined in appendix B that the faders can be assigned to. It does not have to be assigned to Aftertouch, although this is the case in many of the presets. Useful settings for this Aftertouch strip are: < OFF = the strip generates no controller data at all. < 131 = The strip generates Channel Aftertouch. < 001 = The strip generates modulation. MIDI IN and OUT The MIDI In and MIDI Out ports have different uses depending on how you intend to connect and power Ozonic. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · · · · Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ]