User manual MACLAREN TWIN TECHNO

[. . . ] (Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you. ) This warranty gives you specific legal rights, and you may have other rights which vary from state to state. For warranty service Should repair be needed during the warranty period and under the conditions of the limited warranty, contact the retailer you purchased the product from. If your retailer cannot perform the warranty repair, please contact Maclaren direct at 1-877-442-4622. [. . . ] , other than those approved by Maclaren may damage or break this vehicle. It may be unsafe to use accessories not supplied and approved by Maclaren, items such as child seats, bag hooks, rain covers, buggy boards etc will not be covered by the terms of our warranty. Never leave children in the stroller when ascending or descending stairs or escalators or when travelling on other forms of transport. The stroller should always open and fold easily. It may be necessary to re-read the instructions. Never allow children to stand on the footrest. Do not leave the stroller exposed to heat, i. Do not place items on the top of the hood as it may cause damage to the hood. WARNING: This Stroller is not suitable for running or skating. € • • • • • • If the stroller chassis parts have been exposed to salt water we recommend that they be rinsed down with fresh (tap) water as soon as possible afterwards. € The hood may be sponged lightly using a damp cloth and a mild detergent. The seat may be washed - see care label for details. Do not fold or store the product while wet and never store in a damp environment as this can cause mildew to form. € • • • • • • • • Maclaren reserves the right to make design changes to any of their products as part of their continuous improvement programme. This product is designed and manufactured to comply with ASTM F833 Standard Consumer Safety Performance Specification for Carriages/Strollers and is JPMA certified. This product is designed and manufactured to comply with Canadian standard SOR/91-350, s. The hood is removed by firmly pressing down the hood release tabs. C Using foot, push BOTH footplates down fully to engage the primary locks. CAUTION: Ensure that all locking devices are engaged before use. 2 TO OPERATE BRAKES A TO ENGAGE BRAKES: With foot, push BOTH brake levers to the far right. CAUTION: Parking device shall be engaged during the loading and unloading of children. CAUTION: Ensure parking device is engaged before leaving the buggy unattended. [. . . ] B Insert both waist clips into the clasp, shoulder straps are secured once the clips are fastened. TO RELEASE HARNESS: D Press the button on both the front and back of the clasp simultaneously to release. 5 TO FIT HEAD CUSHION ( If Supplied) A Unclip shoulder harness straps from clasp and pass through head cushion holes. B Fold pad over and secure Velcro strips 7 TO ADJUST SEAT RECLINE A TO RECLINE SEAT BACK: Lift both hand grips to release seat locks and recline the seat back to desired position. [. . . ]