User manual MACROM ECS260

[. . . ] Graph The wide smooth frequency response, good sensitivity and high power handling make the ECS 2. 60 suitable for use in any quality installation CAR AUDIO EQUIPMENT ® ECS 2. 60 Specifications Power Handling: Nominal Impedance: Frequency Response: Sensitivity (1W/1m): WOOFER Unit Size ø - 160 cm (6 1/4") Voice coil ø - 54 mm (2 1/4") Aluminium Cone Material CMP - Composite Metalised Paper Magnet System: Triple magnet Nett Weight (per piece): 0. 720 Kg Resonant Frequency: Dc Resistance: Voice Coil Inductance @ 1Khz Air Gap Height: X-Max Linear Excursion: Force Factor (BXL) Qms: Qes: Q/Ts: VAS: Cms: Moving Mass (ms): 60 Hz 3. 10 Ohm 0. 22 mH 4 mm ± 3 mm 3. 50 tm 4. 85 1. 28 1. 00 10 lt 494 µM/N 12 gr TWEETER Unit Size Voice coil Dome Material Magnet System: Resonant Frequency: Dc Resistance: ø - 50 mm (2 ") ø - 25 mm (1") Soft Linen Neodymium 1, 800 Hz 4 Ohms 120 Watts (max. music) 3 Ohms 45-25, 000 Hz 90 dB Installation Guide Illustrated Options for Specific & Standard Installation MACROM LTD. [. . . ] To do so apply slight pressure to the edge close to the dust cap support. Insert the tweeter in the support pushing it down until it is hooked into position. Follow the indications on the tweeter for the indentification of the negative (-). To select the desired tweeter option, insert the tweeter in the appropriate position following the indications on the support. The crossover filter is inside the magnet cover and therefore the use of external components is not necessary. The built-in crossover filter will be activated when the tweeter is inserted in the support. Tweeter option The tweeter offers four options: 0dB, in phase / 0dB, Out of phase / -3dB, in phase / -3dB, out of phase. These four options can be used in both the Combinable and Separate modes. We suggest using the 0dB in phase when first installing the speakers. Insert the tweeter in the support following the, indications of the negative (-) on the side of the tweeter (indicated with on the drawing). Surface installation (C) + Flat FLAT (0dB) In Phase - How to Remove the Dust Cap Rotate the dust cap by about 15° in an anti-clockwise direction, at this point the dust cap is no longer locked into position and is ready to be lifted out with an upward movement. There is a triangle on the dust cap which is lined up with a vertical plastic indicator when the dust cap is locked into position. [. . . ] From Tweeter support To crossover tags Red = FLAT (0dB) . Black = - Negative . (B) + ATT (-3dB) Outof Phase - ATT + ATT + (A) ATT - + Flat + - ATT - [. . . ]