User manual MAGIC CHEF MCWC52B

[. . . ] · In case the interior accessories are not correctly placed, rearrange them as described in chapter "Description of the Appliance". Instructions for Use These instructions for use are intended for the user. They describe the appliance and correct operating procedures for safe use . SAVE THESE INSTRUCTIONS: · If the gasket is damaged or the door seal is poor, energy consumption is substantially higher. [. . . ] Defrost Water Outlet The interior of the appliance is cooled with a cooling plate mounted in the rear wall. Under the plate there is a channel and an outlet for defrost water. Regularly check the defrost water outlet and the drain channel for blockage. They should always be kept free and clean of particles. WE RESERVE THE RIGHT TO ALTER THE SPECIFICATIONS WITH NO EFFECT ON THE OPERATION OF THE APPLIANCE. Temperature Control The temperature of the appliance is controlled by setting the thermostat knob to a desired setting. Temperature Selection To start the appliance turn the temperature control knob to the position corresponding to the desired cooling. The temperature control knob is illustrated on page 6. The temperature will vary depending on the quantity of the item stored and on the frequency with which the door is opened. To turn the control to the "OFF" position, rotate the control knob to the "0" position. If the appliance has been left out of use for some time, set the control to maximum or the "7" position for 2-3 hours before turning to the desired position. If the appliance is not being used for long time periods, disconnect the plug and leave the door partially open. This will help to reduce mold/mildew from accumulating inside the appliance cabinet. Warning: Never set the temperature control to maximum or "7" position for more than 8 hours. 5 TEMPERATURE CONTROL KNOB . Changes in ambient room temperature will affect the internal temperatures (choose correct setting of the thermostat knob). In STOP (0) position the appliance does not operate (cooling system is switched off ), yet power supply is not interrupted. Temperature in the appliance also depends on how often the door is opened. THERMOSTAT DIAL: For controlling the temperature inside the wine cooler. Turns the motor on as soon as the temperature rises above the desired level. PLASTIC COATED SHELVES: Odor resistant, rustproof, and removable for easy cleaning. DOOR SEAL: Tight fitting door seal keeps all the cooling power locked inside. TEMPERED GLASS DOOR & INTERIOR LIGHT: Allows easy interior visibility. 6 Maintenance and Cleaning Automatic Defrosting of the Appliance There is no need to defrost the cooler , because ice depositing on the inner back wall is defrosted automatically. Ice build-up on the inner back wall during the compressor operation will defrost automatically (when the compressor has cycled off) . Defrost water will drain out passing through the drain outlet in the inner back wall into a drain pan situated above the compressor, from where it evaporates. Clean the exterior with water and detergent. [. . . ] . Content losses due to failure of the unit. Inside components such as door panels, door shelves, racks, light bulbs etc. . . Punctures to the evaporator system due to improper defrosting of the unit. Repairs performed by unauthorized service agents. [. . . ]