User manual MAGIMIX ROBOT CAFE

[. . . ] Robot Café F Mode d'emploi NL Gebruiksaanwijzing UK Instructions for use Please read these instructions carefully before using your Robot Café and keep them in a safe place. With the entirely automatic Robot Café, you will rapidly master the art of making genuine espresso, cappuccino or filter coffee. Your Robot Café Is equipped with : · a powerful 15-bar pump : for creamy coffee. · an in-built grinder : for freshly-ground coffee every time. · a system for pre-brewing the ground coffee : to bring out the full flavour. It also allows you to adjust the following : · the amount of water per cup : for a large or small coffee (p. 54). [. . . ] Never put in anything other than ground coffee. · Press the = button for 1 cup or the = button for 2 cups. The coffee will start to flow and automatically stop at the preselected volume while the coffee is flowing. 55 English Using the nozzle The nozzle is used to froth milk for cappuccinos and hot chocolate, as well as to heat liquids. You can also make hot water for teas and infusions or preheat your cups. Steam · Check that the machine is ready ( · Slide the steam pipe : - Up : to heat liquids. · Partly fill a tall, narrow container (e. g. a small jug) with the liquid you wish to heat (1/3 full for milk and 2/3 full for other liquids) and place it under the nozzle. Do not touch the nozzle, as it becomes extremely hot. When handling the nozzle, always hold it by the plastic ring. · Lower the steam nozzle into the container and turn the hot water /steam selector towards as far as it will go. Some water will be dispersed before the steam appears. This is quite normal and does not affect the end result. Lower the nozzle halfway down into the liquid, making sure that it does not touch the bottom of the container, so as not to prevent the inflow of air. Make gentle circular movements downwards. NB : It takes a few seconds for the temperature to rise sufficiently for steam to be produced. The pump is triggered at regular intervals (staccato noise). · To stop the production of steam, turn the button back to 0 = fill the system with water. · Filling the system with water : - Place an empty container under the nozzle, turn the selector towards as far as it will go and immediately press the button : the water will flow from the nozzle and then stop of its own accord. NB : to limit any splashing, choose a fairly tall, narrow container. - Turn the selector back to 0 machine ready. - Once a week, empty the tank and clean it with a non-abrasive washing-up liquid. · The drip tray : - When comes on and / or the tray's red float becomes visible, you must empty the grounds tray and the drip tray : 1. If necessary, raise the flow head as high as possible. Left the drip tray up slightly before pulling it out. [. . . ] If you use an extension lead, this must be fitted with an earthed plug. · Never use the appliance if the power cord has been damaged. Any damaged cord must be replaced either by the manufacturer, by a Magimix-approved repair service or by a similarly qualified person, in order to avoid all danger. · Always unplug your appliance when filling the water tank, moving the machine, cleaning it or in the event of an anomaly. [. . . ]